Marantz RC5200 manual Customizing Your RC9200/5200

Customizing Your RC9200/5200

User Guide

and creating a new Macro group.

3Use DEL mode to delete all of the macro groups that you don’t like (see page 40-42).

4Use ADD mode to add a new macro group empty of any programming (see page 35-40).

5Switch to LABEL mode to relabel your Macro group (see page 32-34).

6Switch to MOVE mode to re-order your Macro groups, so that the most commonly used Macro groups are near the top (see page 39-40).

7Switch to LABEL mode and navigate to the your new Macro group. Relabel the macro buttons (currently labeled New Macro) with an appropriate name. The buttons are large so try to imagine a descriptive name even if it requires a few words.

8Switch to Edit mode.

9Press your newly named Macro button to enter the EDIT window.The EDIT window will appear. If you had any previously programmed commands in this button, they will appear for you to edit.

10 Working from your written list, navigate to the desired device and panel to program all of the steps in the Macro (see step 5 on page 44).

Commands - When you touch a button, you will record an RC command step (see page 43).

Jumps - When you select a device from the Device Menu while holding down the Left hard button (now called device), you will record a panel jump to the last accessed panel of that device (see page 43).

Delays - When you select Delay, use the plus and minus arrows to set the amount of delay (see page 44).

25