
Reference
8Repeat instructions 1 to 3 for all devices for which you want to change the RF IR settings.
9Tap Close.
The Remote Control switches back to Use mode. The Remote Control is configured to operate the devices you have set with RF signals.
10 Try out the devices for which you just changed the RF IR settings.
Note It is possible that a device does not respond properly when operated with RF signals. In that case, you have to reconfigure the Remote Control to operate the device with IR signals again.
Choosing Another Channel
When you notice RF interference or unreliable operation you should try choosing another channel to operate your devices.
Note All devices you want to operate with RF signals use the same channel. If you choose another channel for one device, the Remote Control will automatically change the channel for all devices that work with RF signals.
1Switch back to RF IR mode. The Device menu appears.
2Select a device that is set with RF signals. The RF IR settings appear.
3Tap Channel. The button label turns red indicating that the button is active.
4Press the Left and Right hard buttons to change the Channel. The Remote Control offers 4 RF Channels.
Note The Channel (CH) on the RF Extender has to match the Channel on the Remote Control.
5Tap Accept.
6Tap Close.
User Guide |
49