Marantz RC9500 manual Installing the Battery Pack

Page 8

DFU RC9500 Ver1_2.qxd 5/28/2004 10:32 AM Page 8

Introduction

Installing the Battery Pack

1Press the latch on the battery cover and remove the battery cover from the RC9500.

1

2

2Plug the cable of the battery pack in the connector as illustrated.

3Place the battery pack in the battery compartment.

3

4

4Place the battery cover back on.

Note Make sure the cable of the battery pack does not get stuck

between the molded interior and the battery cover.

After a few seconds, the RC9500 starts up automatically and an introduction screen appears. The RC9500 beeps twice to indicate that it has finished starting up.

Because the battery pack of the RC9500 is not fully pre- charged, you will have to charge it as described in the next page.

User Guide

4

Image 8

Contents Model RC9500 User Guide FCC Compliancy Declaration of Conformity N V04ECRC9500DFU RC9500 Ver12.qxd 5/28/2004 1032 AM RC9500 Remote Control User Guide Automating Your Home Theater With The Marantz RC9500Table of Contents Introduction Marantz RC9500Battery IntroductionInstalling the Battery Pack Charging the RC9500 Using the Backlight Getting StartedActivating the RC9500 Turning on the Touch ScreenNavigating the Devices Navigating the RC9500Modes Device Overview Navigating the Pages OverviewOther Navigation Using the Soft Buttons Using the Hard ButtonsSending commands Operating a DeviceSetup Pages To exit the InformationFirst Setup Changing the Time Setting Time and DateChanging the Time Format Changing the Date „ To Change the Day„ To Change the Month „ To Change the YearMode Menu So on, you have to switch to the appropriate modeAdjusting the Touch Screen Brightness To switch to another modeCloning All Your Existing Remotes Customizing your RC9500Introduction Congratulations Complex Operation? Macro or Help Tip Tap Copy without RC codes when it prompted. see Programming Help ListMacros Perform Jumps to Any Device Macro/Page Jump CapabilityAny Button Performs Macros/Jumps Macros Send Commands To Your System Macros Can Contain Delay and Beep Between StepsProgramming Macros & Page Jumps Customizing Your RC9500 You are now a Home Theater Automator Learning IR command ReferenceProgramming Touch Screen Buttons Programming The Device Buttons Device Action Programming the Hard Buttons per DeviceReference Labeling Buttons, Pages and Devices Labeling a ButtonReference Labeling a Device Labeling aAdding Devices Description for the Device Template„ Create New Device „ Copy Existing Device Device TemplateReference Creating a New Device Step by Step Copy Existing Device Deleting Buttons and Devices Deleting a ButtonDeleting a Device Moving Devices Adjusting Delays Programming MacrosMacro Page Notation DVDRecording a Macro to a Operation Button Step By Step Tap the Macro to Button button to proceed to the next stepRecording a Device Action Source or Input Switching Recording a Jump to a DeviceEditing Macros Creating and Editing Timers Adding a TimerActivating Timers Deleting a Timer Labeling a TimerEditing a Timer Set the Start Time Define the Repeat SettingsSet the Start Date To change the Start Date Setting the Start DateSetting the Start Time or Stop Time Defining the Repeat Setting Defining the Start Action or Stop Action„ Daily „ Weekly Using the RC9500 with Radio Frequency Changing the IR / RF SettingsReference Software Choosing Another ChannelInternet Fun PC RequirementsImportant Notice Cleaning the RC9500Maintaining Your RC9500 Troubleshooting General ProblemsProgramming Problems Recharging Problems Frequently Asked Questions How do I calibrate the Touch Screen? Overview of Symbols Overview of Symbols Specifications DisplayVolume IndexDSS ADD Operating Other Updates and New Products Service and SupportService and Support Memo Japan