ENGLISH |
Introduction | Introduction |
Introduction Connections Playback
Part Names and Functions
Front Panel
7 | 8 | 9 |
| 10 11 12 |
1 2 |
| 3 4 | 5 | 6 |
The unit can also be turned on by pressing the buttons with circled numbers.
Rear Panel
1 | 2 | 3 | 4 | 5 | 6 | 7 |
AC IN | DIGITAL OUT COMPONENT VIDEO OUT VIDEO OUT | FLASHER |
| |||
|
|
|
| IN | OUT |
|
| COAXIAL |
|
|
|
|
|
|
|
|
|
| FL | C | SL | SBL |
|
| STRAIGHT | 2ch AUDIO OUT |
|
|
| |
|
| CABLE | R | L |
|
|
|
NETWORK | HDMI OUT |
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
| FR | SW | SR | SBR |
|
|
|
|
| 7.1ch AUDIO OUT |
| |
8 | 9 | 10 |
|
|
|
|
|
Function Setup Others
1.STANDBY indicator
This indicator lights up in red in standby mode and turns off when the power is on.
2.POWER ON/STANDBY button
Press to turn on the unit, or to turn the unit to the standby mode. (In standby mode, this unit still consumes small amount of power. To completely shut down the unit, you must unplug the AC cord.)
3.HDMI RESOLUTION button
Press to set the HDMI jack’s video signal output mode.
4.Infrared sensor window
Receives signals from your remote control so that you can control the unit from a distance.
5.Display
Refer to “Front Panel Display” on page 9.
6.SD card slot
Insert an SD Memory Card, and play back the contents in it.
7.H / G (SKIP DOWN/UP) button
Press to skip down/up titles/chapters/tracks/ files.
8.A (OPEN/CLOSE) button
Press to open or close the disc tray.
9.Disc tray
Place a disc when opening the disc tray.
10.B (PLAY) button
Press to start or resume playback.
11.C (STOP) button Press to stop playback.
12.F (STILL/PAUSE) button Press to pause playback.
1.AC IN Terminal
Use to connect the AC cord to supply the power.
2.DIGITAL OUT (COAXIAL) jack
Use digital audio coaxial cable to connect to an AV receiver, Dolby Digital decoder or other device with a digital audio coaxial input jack.
3.COMPONENT VIDEO OUT jacks
Use a component video cable to connect to a display device with component input jacks.
4.VIDEO OUT jack
Use an RCA video cable to connect to a TV monitor, AV receiver or other device.
5.FLASHER IN / OUT jacks
This Input terminal is equipped for controlling this unit by the external Infrared (IR) control device. Connect the IR control signal from a Keypad, IR repeater, etc. The Output terminal repeats the IR signal which was fed into the IR Flasher Input terminal for another device.
6.2ch AUDIO OUT jacks
Use an RCA audio cable to connect these jacks to the
7.7.1ch AUDIO OUT jacks
Use an RCA audio cable to connect these jacks to the
8.NETWORK Terminal
Use to connect a telecommunications equipment with LAN cable.
9.HDMI OUT jack
Use an HDMI cable to connect to a display with an HDMI input jack.
10.CONTROL CONNECTOR (RS-232C)
This is a terminal for future system extension.
Note
•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.
7
ENGLISH