ICP DAS USA user manual Quick Starting the 7000 Series

7.Quick Starting the 7000 Series

7.1Find Status of Unknown Module

Wire connection: Refer to Sec. 2.7

Test program: Refer to “NAP7000S User Manual” for TEST.EXE

Connect I NIT*_pin to GND_pin first as follows.

The steps to finding the status of an unknown module are given as follows.

1.Wire connection, INIT*_pin=GND, power on and run test.exe

2.Press 2

3.	Press $002[Enter]	Receive=! 02080A40
4.	Press 2
5.	Press %0001080600[Enter] Receive=! 01

6.Power off, disconnect INIT*_pin (pin 6) and GND_pin (pin_10) and power on

7.Press 2

8.	Press $012[Enter]	Receive=! 01080600
9.	Press 2
10. Press $01M[Enter]		Receive=! 017017
11.	Press 2
12. Press $01F[Enter]		Receive=! 01A1.3
	Step 3: read the	module status with the INIT*_pin connected to the

GND_pin and find that module address=02, baud rate= 115200, checksum is enable.

Step 5: change this module to address=01, baud rate=9600, checksum

disable

Step 6-12: disconnect the INIT*_pin and read back the module status

NOTE: If the INIT*-pin is connected to GND-pin, the 7xxx will go to its default setting as follows:

(1)Module address=00; (2) baud rate=9600; (3) checksum is disable

7000 Bus Converter User Manual (version 1.2,Feb/2003, 7PH-006-10) --------------- 80