ICP DAS USA 7000 user manual 7510, 7513

3.2.1	The I-7561	System Network Configuration:	39
3.2.2 The I-7561		Block Diagram:	39
3.2.3	I-7561 has three different Output type		40

3.2.4I-7561 is designed Termination resistor (120 Ohm) on board 40

	3.2.5	I-7561 Driver Installation	42
	3.2.6	Installation under Win2000/XP	42
	3.2.7	Install USB COM port	45
	3.2.8	Uninstall drivers	47
	3.2.9	Installation under Win98/ME	49
3.3		I-7563 Pin Assignment and Specifications:	54
	3.3.1	The I-7563 System Network Configuration:	55
	3.3.2 The I-7563 Block Diagram:		55
	3.3.3	I-7563 Driver Installation	56
	3.3.4	Verifying the Installation:	60
	3.3.5	Uninstalling the Device Driver	63
4.I-7551			64
4.1		I-7551 Pin Assignment and Specifications:	64
	4.1.1	The I-7551 System Network Configuration:	65
	4.1.2 The I-7551 Block Diagram:		65
5.I-7510 /I-7510A /I-7510AR /I-7513			66
5.1		I-7510:	66
	5.1.1	Pin Assignment and Specifications:	66
	5.1.2	Block Diagram:	66
5.2		I-7510A:	67
	5.2.1	Pin Assignment and Specifications:	67
	5.2.2	Block Diagram:	67
5.3		I-7510AR:	68
	5.3.1	Pin Assignment and Specifications:	68
	5.3.2	System Network Configuration:	69
	5.3.3	Block Diagram:	69
5.4		I-7513:	70
	5.4.1	Pin Assignment and Specifications:	70
	5.4.2	System Network Configuration:	71
	5.4.3	Block Diagram:	71
5.5		Basic Wire Connections for I-7510	72
6.7000	RS-485 Networking		73
6.1		Standard/Isolation Configuration	73
6.2		PLC Networking Applications	77
	7000 Bus Converter User Manual (version 1.2,Feb/2003, 7PH-006-10) ---------------		3