Krell Industries DVD Player manual Steps J-M. Install the Hdmi Adapter PCB

Steps J–M. Install the HDMI Adapter PCB

J.Locate the HDMI connector on the back edge of the supplied HDMI adapter PCB (not illustrated) and slide it into the HDMI connector through hole (6) on the back panel (see Figure 3) of the Showcase DVD.

K.Secure the HDMI adapter PCB to the back panel using two supplied 4-40 x 1/4- inch SHSC (7) (see Figure 3).

L.Position the left front through hole on the HDMI adapter PCB over the standoff protruding up from the analog output board (not illustrated).

M.Thread one supplied 4-40 x 1/4-inch SHSC (28) onto the standoff to support the front left corner of the HDMI adapter PCB (see Figure 4).

Audio sync switch

Figure 3

Showcase DVD Back Panel

Showing HDMI Connector,

After HDMI Adapter PCB Is

Installed

6Connector through hole with HDMI connector in place

7two 4-40 x 1/4-inch SHSC

76

Steps N–P. Install the HDMI Power PCB

N. Mount the supplied HDMI power PCB onto the Showcase DVD chassis using the four supplied 4-40 x 1/2-inch SHCS (8); one in each corner of the board. (see Figure 4).

O. Secure the regulator to the chassis with the supplied 4-40 x 3/8-inch FHTS (9) and cap it with the supplied 4-40 Kepnut (10) (see Figure 4).

P. Tighten until “just snug”. The torque spec is 5-8 in lbs.

4Showcase DVD / HDMI Upgrade