Sony KV-G142M service manual Item No VPX

KV-G14M2

RM-869

Option Note

Item No. 13 VPX

Item			HCO	EVG	SBL	PRD		–	–	–	VID
Initial data			0	0	0		0	0	0	0	0
HCO	EHT Tracking Mode			1 = on V and E–W.		0 = only on V
EVG	Enable Vertical Guard			1 = enable.		0 = disable
SBL	Service Blanking			1 = active.		0 = inactive
PRD	Over-voltage Protection Detection					1 = enable. 0 = disable
VID	Video Ident Mode			1 = not for ø1-loop		0 = for ø1-loop
Item No. 3E OP0
Item			No TOP	AV input		AVMUT		B/G	I	D/K	M
Initial data			0	1	0		0	1	1	1	1
AV Input	0	0	no AV input model		0	1	1 AV input model
	1	0	2 AV input model		1	1 2 AV input and RGB input model
No TOP (for teletext model)				1 = only FLOF available.			0 = both FLOF and TOP available
AV MUT	1	= AV multi is always muted if no signal input.					0 = not muted always
Other optional bits are effective if set to 1.
Item No. 3F OP1
Item			No NICAM	–	HDEV	1 V-Curve		XTAL SEL		SECAM	2nd Lang.
Initial data			0	0	0		0	1	1	1	1
XTAL SEL 0		0	only 4.43 XTAL		0	1	only 3.58 XTAL
	1	0	(not used)		1	1 both 4.43 and 3.58 XTAL
1 V-Curve (for monaural model)
	1	= using common volume curve for every mode and every TV system
	0	= another volume curve available for video mode and M system
HDEV	1	= High Deviation Mode switch available.				0 = not available
Other optional bits are effevctive if set to 1.
Item No. 40 OP2
Item			–	–	No. Bal	TV Out		Hotel	VM	D.B.F.B.	Thai Bil.
Initial data			0	0	0		0	0	0	0	0
No Bal. (for AV stereo model)				1 = no balance in analog select items.				0 = balance included
Other optional bits are effective if set to 1.

Hotel TV mode should be switched with remote commander from STBY condition as below.

Hotel TV on : push “display”. “8”. “vol +” and “power” sequentially

Hotel TV off : push “display”. “8”. “vol –” and “power” sequentially

– 21 –