Using Two VCRs for Copying and Editing Tapes
Operating Instructions ukfer t0 hookup 0” page 6.~
Use one VCR as the playback VCR and the other as the recording VCR.
cation: Theu”a”tho”zed
1. Turn on the TV and VCRs.
2. Tune TV to the VCR viewing channel, either 3,4, or TV’s video input.
mcor&ngofLelevlslon ri p’0grarn~andother
materialrmaylnti”“gethe
nghtsofc&err.
3.If you have connected your VCR using Option A @age 6), tune recording VCR to channel 3 or 4
If you have connected your VCR using Option B (page 6% press INPUT on recording VCR’s remote to select the line input. L appears in VCR’s display panel.
4.Insert the tape you want to copy into playback VCR. Insert a blank tape with safety tab in place into recording VCR.
5.Press PLAY/PAUSE on the playback VCR to play the tape. When you reach the point on the tape or program where you want to begin copying, press PLAY/PAUSE to pause the tape. If streaks appear, you may need to adjust
TRACKING.
6.Press RECORD, then PLAY/PAUSE on recording VCR.
7.Press PLAY/PAUSE buttons on both VCRs at the same time to begin copying the tape.*
8.Edit out segments that you do not want to copy by pressing PLAY/PAUSE on recording VCR to stop copying the tape. Then, locate the next segment you want to copy on playback VCR by using F.FWD, REW, and PLAY/PAUSE. Then press PLAY/PAUSE on the playback VCR to pause the tape. Press PLAY/PAUSE at the same time on both VCRs to resume copying.
9.Press STOP/EJECT on both VCRs when you are finished.
’You may bun off the TV after the recording has started as it does not have to be on to copy a tape.
Using Dual Remote with AutoEditTM
Usethis VCR as the recording VCR and set it to respond to VCR2 on the remote as demikd on page 12. Use your other compatible VCR as the playback VCR which should respond to VCR1
1.Follow steps 1 - 4 in “Operating Inshuctions” above.
2.Press VCR2 on remote to control recording VCR. Press REC/XPR, then PAUSE, to put recording VCR in pause mode.
3. Press VCR1 on remote to control playback VCR. | , |
|
4.Use PLAY, F.FWD, and REW, to locate the point where you want to begin copying. Press PAUSE while VCR is playing to put playback VCR in pause mode.
5.Press EDIT on remote; the VCRs will begin copying.
6.Press EDIT again when you want to stop the tape from copying.
7.Repeat steps 4 - 6 as needed.
8.Press VCRl, STOP, then VCR2, STOP, when you are finished.
26
ml 1