Pioneer Mastering Recording and Timer Functions of the DVR 7000

05Recording

Basic recording from the TV

VR mode Video mode

Follow the instructions below to record a TV program. Recording starts immediately and continues until the disc is full or you stop the recording.

HDDDVD

CH

CLEAR

AUDIO

ENTER

PAUSE

REC STOPREC REC MODE

1Load a Recordable disc.

•if you load a new blank DVD-RW disc, the recorder takes a short while to initialize the disc.

2Use the CH +/– buttons to select the TV channel to record.

The front panel display shows the channel number:

Channel preset

•While the recorder is stopped, you can also use the number buttons on the remote to select the channel. (For channel 6, press 6 then ENTER; for channel 24, press 2, 4 then ENTER)

•If the recorder is stopped, you can also use the +/– buttons on the front panel to select the channel number.

34

3Use the REC MODE button to set the picture quality/recording time.

•See Setting the picture quality/recording time on page 33 for detailed instructions.

4Use the AUDIO button to select the audio channel to record.

See Changing audio channels on page 26 for more on this.

•When recording in VR mode, if a broadcast is bilingual, both audio channels are recorded, allowing you to switch the audio channel on playback. The only exception to this is when the picture quality is set to LPCM, in which case you do need to select the audio channel before recording.

5 Press REC to start recording.

If you want to set a recording end time, press the REC button repeatedly. The recording time increases in 30 minute increments, up to a maximum of six hours. The time the recording will end is shown on-screen and in the front panel display. When the recording ends, the recorder automatically switches into standby if no other operation is being performed.

• To cancel the set recording time, press REC.

• If you want to pause recording at any time, press PAUSE. Press again to restart the recording. (If

recording in VR mode, a new chapter is started after recording restarts)

6 To stop the recording, press STOP REC.

•If you set the recording time in the previous step, you can still stop the recording anytime by pressing

STOP REC.

•Recording will stop automatically when there is no more space on the DVD.

Setting a timer recording

VR mode Video mode

Using the timer recording features you can program up to 32 timer recordings up to a month in advance. Timer recording programs can be set to record just once, every day, or every week.

There are three ways to program a timer recording; using the Easy Timer Recording feature (see Easy Timer Recording below), using the G-Code programming system (see Timer recording using the G-Code™ programming system on page 36), or using manual timer recording (see Setting a manual timer recording on page 37).

You can set the recording quality for your timer recording in the same way as for a regular recording, but with the added option of an AUTO mode, which maximizes the recording quality for the space available on the disc.

En