RCA HD65W40 manual Program information doesn’t download, Scheduled Watch or Record doesn’t occur

References

GUIDE Plus+ System Problems

GUIDE Plus+ setup won’t turn off tape for VCR setup and/or channel 02 cable box

•Check to see if the G-LINK wands are positioned correctly in front of components’ remote sensors.

•GUIDE Plus+ system control of cable box is slower than direct control of the box itself. Keep this in mind when changing channels.

•You may have an incorrect GUIDE Plus+ channel lineup. The guide may get out of sync with the cable provider. Use the GUIDE Plus+ setup in the GUIDE Plus+ menu to change the zip code to 99999. Turn the TV off for 10 minutes. Use Setup again to change the zip code back to the correct value. If asked, be sure to select the correct channel lineup from the on-screen list.

Program information doesn’t download

•Review your setup information and make sure it’s correct. Press MENU on the remote and select GUIDE Plus+ system menu and then Setup. Go to page 21 for detailed instructions about the GUIDE Plus+ setup menus.

•The TV must be off to download information. Leave your TV off overnight, for at least 10 hours, to receive the initial download for your area.

•If you’re using a cable box, leave it on so you can receive program information.

•The GUIDE Plus+ system doesn’t display program listings for satellite TV.

Scheduled Watch or Record doesn’t occur

•Check Schedule for timer conflicts. Go to page 40 for instructions.

•Make sure the wands of the G-LINK cable are placed in front of the remote sensor(s) on the component(s).

•Make sure your VCR is turned off during the time you’ve scheduled to record a program because the system turns the VCR on when it starts recording (if it’s already on when recording starts, the system will turn it off).

•Make sure there is a tape in the VCR and that the VCR is connected properly.

•Make sure VCR is tuned to the line input. Don’t change channels.

•Be sure that you set up the VCR in the GUIDE Plus+ setup menus. If you don’t complete the Configuring for a VCR steps successfully, the Record option won’t be available. Go to page 23 for detailed instructions.

•If a cable box is attached to your TV, make sure you set it up correctly in the GUIDE Plus+ setup menus. Go to page 22 for detailed instructions.

•The guide comes up each time you turn on the TV. You can disable the guide by going to the Auto-on feature in the Setup menu and select Review Options.

72 Chapter 5