Panasonic TH-42PR10UA Enable, Function, Normal Standby, Initial Power, Mode, ID select, Serial ID

Options Adjustments

Options 2/3

Off-timer function	Enable
Initial Power Mode	Normal
ID select	0
Remote ID	Off
Serial ID	Off
Display size	Off
Studio W/B	Off
Studio Gain	Off

Item	Effect						Adjustments
Off-timer			Enable:		Enables the “Off-timer function”.
			Disable: Disables the “Off-timer function”.
function	Enable	Disable
			Note: When “Disable” is set, the Off-timer is cancelled.
			Normal		Standby	On
			Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Initial Power			Normal: Power returns in as the same state as before the power interruption.
Mode			Standby: Power returns in standby mode. (Power Indicator : red/orange)
			On:		Power returns in power On. (Power Indicator : green)
			Note:		When using multiple displays, “Standby” is preferred to be set in order to reduce a power load.
			Sets panel ID number when panel is used in “Remote ID” or “Serial ID”.
ID select			Set value range: 0 - 100
			(Standard value: 0)
Remote ID			Off:	Disables ID remote control functions. You can use normal remote control operations.
	Off	On	On: Enable ID remote control functions.
			Sets the panel ID Control.
Serial ID	Off	On	Off: Disables external control by the ID.
			On: Enables the external control by the ID.
			Adjusts the image display size on screen.
			Off:	Sets the normal image display size on screen.
			On:	Sets the image display size approximately 95 % of the normal image display.
					Off		On
Display size	Off	On	Notes:
			• This setting is valid only when the input signals are as follows;
			NTSC, PAL, SECAM, M.NTSC, PAL60, PAL-M, PAL-N (BNC Dual Video Terminal Board (TY-FB9BD))
			525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/30p,
			1250/50i (Component Video, RGB, DVI, SDI, HDMI)
			• This setting is invalid when two screen display, digital zoom or Multi screen is selected.
			• When “Display size” is set to “On”, “POS. /SIZE” adjustment cannot be used.
			• Refer to each board’s operating instruction for DVI, SDI, HDMI’s corresponding signals.
			Off:	Nullify all the settings adjusted.
Studio W/B	Off	On	On: Sets the color temperature for TV studio.
			Note: Valid only when the low is set as color temperature on screen adjustment.
			Sharpens the contrast for a better view when a part of the image is too light to see.
			Off:	Disables “Studio Gain”.
Studio Gain	Off	On	On:	Enables “Studio Gain”.
			Note: This setting is valid only when the input signals are as follows:
				Component Video, RGB (analog), SDI, HDMI

37