Panasonic 103PF12U manual Advanced Settings, Picture Adjustments

PICTURE Adjustments

Item	Effect		Adjustments
PICTURE	Less	More	Adjusts the proper picture contrast.
BRIGHTNESS			Adjusts for easier viewing of dark pictures
	Darker	Brighter	such as night scenes and black hair.
COLOR	Less	More	Adjusts color saturation.
TINT	Reddish	Greenish	Adjusts for natural flesh tones.
SHARPNESS	Less	More	Adjusts picture sharpness.

Notes:

•“COLOR” and “TINT” settings cannot be adjusted for “RGB/PC” input signal.

•You can change the level of each function

(PICTURE, BRIGHTNESS, COLOR, TINT, SHARPNESS) for each PICTURE MENU.

•ThesettingdetailsforSTANDARD,DYNAMIC and CINEMA respectively are memorized separately for each input terminal.

•The “TINT” setting can be adjusted for NTSC signal only during “VIDEO (S VIDEO)” input signal.

•In PICTURE, there is not a noticeable change even when contrast is increased with a bright picture or reduced with a dark picture.

ADVANCED SETTINGS

Item	Effect				Details
BLACK			Adjusts the dark shades of the image in gradation.
EXTENSION	Less	More
INPUT			Adjustment of parts which are extremely bright and hard to see.
LEVEL	Less	More
			S+ CURVE*1	S CURVE		2.0	2.2	2.5	2.6*2
			*1 When “PICTURE MENU” is set to “DYNAMIC”, GAMMA “S+ CURVE” can be
GAMMA			selected. When 2k1k signals are received with the Dual Link HD-SDI Terminal
	Down	Up	Board (TY-FB11DHD), “S+ CURVE” cannot be selected.
			*2 When 2k1k signals are received with the Dual Link HD-SDI Terminal Board (TY-
			FB11DHD), GAMMA “2.6” can also be selected.
AGC	OFF	ON	Increases the brightness of dark signal automatically.
W/B HIGH R	Less	More	Adjusts the white balance for light red areas.
W/B HIGH G	Less	More	Adjusts the white balance for light green areas.
W/B HIGH B	Less	More	Adjusts the white balance for light blue areas.
W/B LOW R	Less	More	Adjusts the white balance for dark red areas.
W/B LOW G	Less	More	Adjusts the white balance for dark green areas.
W/B LOW B	Less	More	Adjusts the white balance for dark blue areas.

Notes:

•Carry out “W/B” adjustment as follows.

1.Adjust the white balance of the bright sections using the “W/B HIGH R” , “W/B HIGH G” and “W/B HIGH B” settings.

2.Adjust the white balance of the dark sections using the “W/B LOW R” , “W/B LOW G” and “W/B LOW B” settings.

3.Repeat steps 1 and 2 to adjust.

Steps 1 and 2 affect each other’s settings, so repeat each step in turn to make the adjustment.

•The adjustment values are memorized separately for each input terminal.

•The adjustment range values should be used as an adjustment reference.

Helpful Hint ( /

NORMALIZE

Normalization)

On the remote control unit, while the “ADVANCED SETTINGS” menu is displayed, if either the N button is pressed at any time or the ACTION () button is pressed during “NORMALIZE”, then all adjustment values are returned to the factory settings.

29