Panasonic PT-DW5000UL manual Cleaning and replacement of air filter, Procedure of cleaning

Page 42

Cleaning and replacement of air filter

If too much dust accumulates on the air filter, [AIR FILTER] appears at the lower left of the screen, and the temperature monitor (TEMP) will blink once. If even more dust is allowed to accumulate, the temperature inside the main unit will rise, the temperature monitor (TEMP) will blink twice, and the power is turned off.

Clean the air filter section once every 100 hours or so as a guideline depending on the location of projector operation.

It appears only for 30 seconds within 3 minutes after the power is turned on. It disappears if any of the buttons on the rear side of the main unit or on the remote control is pressed.

Procedure of cleaning

Turn off the main power and remove the power plug from the receptacle.

Turn off the main power supply observing the procedure (Powering off the projector) on page 24 and then remove the power plug.

Dismantle the air filter.

There are two air filters, one at the left and one at the right.

Use your finger to pull the air filter tab toward you, and remove it from the main unit.

Clean the air filter.

Suck off deposited dust with a vacuum cleaner.

Air filter

Attention • Do not to suck in the air filter itself.

•Do not rinse off the air filter with water. Doing so will impair the filter’s ability to provide protection from dust.

Set the air filter.

Set the air filter in the reverse order to step .

Attention • Fit the air filters into place with the filter material facing the back. (The left and right filters have the same shape.)

•The air filter must be fitted in place when using the projector.

Using the projector without the air filter fitted inside, dirt and dust are sucked into the projector, causing failure.

Note • If cleaning cannot remove the dust completely, then it is a sign to replace the air filter. Consult the dealer. In addition, when the lamp unit is replaced, also replace the air filter.

•Be absolutely sure to use the air filter specifically designed for use with the projector.

42

Page 41 Page 43
Image 42
Page 41 Page 43
Contents PT-DW5000UL Commercial UseDear Panasonic Customer Model number PT-D5600U/PT-D5600UL/PT-DW5000U/PT-DW5000ULPT-D5600U/PT-D5600UL/PT-DW5000U/PT-DW5000UL Contents Precautions with regard to safety Do not place liquid containers on top of the projector Do not insert any foreign objects into the projectorAlways disconnect all cables before moving the projector Do not look into the lens while the projector is being used AccessoriesUse only the Specified battery Do not use the old lamp unitPrecautions on handling Name and function of parts When the operation mode selector Set to ComputerFront and side of the projector Status LED lightsRear view of the main unit Controls on rear panel Side-mounted connection terminals Using the remote control unit Effective range of remote control operationLoading dry cells Setting projector ID number to remote control Using the remote control as a PC mouseOperation mode selector switch Installation geometry InstallationUsing a wired remote control Projection schemesProjection distance by projection lens PT-D5600U, PT-D5600ULInstallation PT-DW5000U, PT-DW5000UL 817Calculation formulas for projection distance by lens types Setup precautions ConnectionExample of connecting with AV products Example of connecting with PCsPowering up the projector Making adjustment and selectionProjection Powering off the projector Direct power off functionHow to adjust the lens position to the left or right How to adjust the lensHow to remove the projection lens Choose an item and adjust it using buttonsUsing the Shutter function Automatic adjustment Auto SetupUsing the Freeze function Using the digital zoom D.ZOOM + functionOn-screen menus Structure of menu screensBasic menu operations Menu items settingResetting to the factory default Returning to the previousAdjusting the picture System Adjusting the positionTV-SYSTEM PositionClock Phase ZoomKeystone Digital Cinema Reality How to use Advanced MenuInput Resolution BlankingXGA Mode Sxga ModeRaster Position OPTION1 settings FRONT/REAR OPTION2 settingsLamp Power DESK/CEILINGSystem Information PasswordFAN CONTROL2 FAN CONTROL1Setting the security System requirements Setting the networkConnecting the PC Connection exampleCommunication conditions Factory setting Using the serial terminalsPin assignments and signal names Examples of connectionConnecting to a PC Computer Projector DTE specifications Control commandsCable specifications Pin assignments and controlIndication of lamp monitor Clean the air filter Cleaning and replacement of air filterProcedure of cleaning Dismantle the air filterTiming of lamp unit replacement Replacing the lamp unitLamp unit will be hot after it has been used Lamp unit replacement stepsRemove the two screws securing the fan unit Have a Phillips screwdriver ready ahead of timeSelect the lamp which has been replaced with the and buttons Password change Using Web Browser ControlAccessing from the Web browser Click OKChange password button Mail set up buttonPower On/Off control Shutter control Basic controlError information Monitor informationOK Normal operation Failed Occurrence of trouble Mail setup When Failed has appeared for an item Parameter DescriptionMail setup page Continuing ErrorButton to update settings DNS server set upPOP server setup Ping testContents of mail sent Adjust clockNetwork config Network statusPJLink security authentication Using the PJLink protocolSupported commands Command Control Description RemarksRemote control Symptoms ChecksPower does Not turn onSpecifications PT-D5600U PT-D5600UL PT-DW5000URemote control Power source Length of power supply cord CabinetOutside dimensions Wireless mouse receiverCompatible Signal List PAL-M/PAL60 PAL/PAL-N/SECAMDimensions Installation dimensions diagramTrademark Acknowledgement Concernant LA Sécurité Ne pas surcharger la prise de courant Précautions concernant la sécuritéNe pas couvrir le filtre et la sortie d’air Ne pas retirer le couvercle ou le modifierNe pas placer le projecteur sur des surfaces instables Ne pas placer des récipients de liquide sur le projecteurNe pas mettre d’objets étrangers dans le projecteur Ne pas placer d’objets lourds sur le projecteur ’utiliser que la pile indiquée’utilisez pas un bloc lampe usagé Précautions pour le transport Nettoyage et maintenancePrécautions pour la manipulation Mise au rebutRemplacement de la lampe Période de remplacement de la lampeProcédure de remplacement de la lampe La lampe est chaude si elle vient d’être utiliséePréparez un tournevis Phillips à l’avance INIT. Compt Panasonic Projector Systems Company Technical SupportPanasonic Canada Inc

PT-DW5000UL specifications

The Panasonic PT-DW5000UL is a cutting-edge projection solution designed for professional use in various environments, including conferences, events, and large venues. Boasting a compact and lightweight design, this projector offers an impressive balance of high performance and portability, making it an excellent choice for users who require mobility without compromising on image quality.

At the heart of the PT-DW5000UL is its powerful DLP technology, which delivers stunning 5000 lumens brightness and a native resolution of 1920 x 1200 pixels. This outstanding resolution ensures that images are sharp, detailed, and vibrant, making it well-suited for displaying high-definition content, intricate graphics, and dynamic presentations. The projector’s high brightness level is particularly advantageous in well-lit environments, allowing for clear visibility even in challenging lighting conditions.

One of the standout features of the PT-DW5000UL is its advanced Solid Shine laser technology. This innovation eliminates the need for traditional lamps, resulting in a longer lifespan of up to 20,000 hours. This increase in operational longevity not only reduces maintenance costs but also ensures consistent performance over time. Moreover, the laser light source provides stable brightness and vivid colors throughout its lifespan, ensuring that every presentation looks its best.

The projector also incorporates a highly effective Dynamic Contrast feature, which enhances the depth of the images by adjusting light output automatically based on the content being displayed. This capability results in deeper blacks and brighter highlights, creating a more immersive viewing experience.

Connectivity is another significant characteristic of the PT-DW5000UL. It supports a wide range of inputs, including HDMI, DVI-D, and 5BNC, allowing seamless integration with various devices. Furthermore, the projector supports multi-screen and edge blending capabilities, making it suitable for large-scale presentations and installations that require multiple projectors to work in harmony.

For ease of installation, the PT-DW5000UL features a variety of lens options and a flexible lens shift range, enabling users to adjust the image position without distortion. This adaptability makes it suitable for different venue configurations, whether in an auditorium or an outdoor setting.

In conclusion, the Panasonic PT-DW5000UL stands out as a robust and reliable projector that combines advanced technology with user-friendly features. Its powerful brightness, exceptional image quality, and long-lasting performance make it an ideal choice for professionals seeking a versatile solution for their projection needs.
Top Page Image Contents