Panasonic PT-DW5000UL Lamp unit replacement steps, Remove the two screws securing the fan unit

Page 44

Replacing the lamp unit

Lamp unit replacement steps

Attention • After 1 500 hours (4 000 hours when long life lamp units are used) of operating the same lamp, it

is only possible to operate the unit for approximately 10 minutes. Steps to must be completed within 10 minutes.

Turn the power off by following the steps on page 24, remove the power plug and confirm that the surroundings of the lamp unit have cooled off.

Check that the fan has stopped running.

Lamp unit cover

Lamp unit 2

Lamp unit Fixing screws

Have a Phillips screwdriver ready ahead of time.

Remove the screw securing the lamp unit cover, and then slide the lamp unit cover a little toward the left, and remove it.

Remove the two screws securing the fan unit.

Note • The lamp units are constructed in such

a way that the screws in steps

and

will not fall through completely.

 

Open the fan unit as shown in the figure.

Remove the screws securing the lamp units (two for each unit), take hold of the handles, and remove the lamp units.

Handle

Lamp unit 1

 

Caution

The lamp unit will be hot after it has been used.

You might get burned if you touch it while it is still hot.

Install the new lamp unit.

Use a Phillips screwdriver to securely tighten the 2 lamp unit fixing screws (two for each unit).

Secure the two screws for securing the fan unit tightly.

Slide the cover a little toward the right, and secure it using the screw for securing the lamp unit cover tightly.

Attention • Firmly install the lamp unit and lamp unit cover. If not installed firmly, a

protection circuit will function and the power will not be turned on.

44

Page 43 Page 45
Image 44
Page 43 Page 45
Contents PT-DW5000UL Commercial UseDear Panasonic Customer Model number PT-D5600U/PT-D5600UL/PT-DW5000U/PT-DW5000ULPT-D5600U/PT-D5600UL/PT-DW5000U/PT-DW5000UL Contents Precautions with regard to safety Always disconnect all cables before moving the projector Do not place liquid containers on top of the projectorDo not insert any foreign objects into the projector Accessories Use only the Specified batteryDo not look into the lens while the projector is being used Do not use the old lamp unitPrecautions on handling Name and function of parts When the operation mode selector Set to ComputerFront and side of the projector Status LED lightsRear view of the main unit Controls on rear panel Side-mounted connection terminals Loading dry cells Using the remote control unitEffective range of remote control operation Operation mode selector switch Setting projector ID number to remote controlUsing the remote control as a PC mouse Installation Using a wired remote controlInstallation geometry Projection schemesProjection distance by projection lens PT-D5600U, PT-D5600ULInstallation PT-DW5000U, PT-DW5000UL 817Calculation formulas for projection distance by lens types Setup precautions ConnectionExample of connecting with AV products Example of connecting with PCsProjection Powering up the projectorMaking adjustment and selection Powering off the projector Direct power off functionHow to adjust the lens How to remove the projection lensHow to adjust the lens position to the left or right Choose an item and adjust it using buttonsAutomatic adjustment Auto Setup Using the Freeze functionUsing the Shutter function Using the digital zoom D.ZOOM + functionOn-screen menus Structure of menu screensMenu items setting Resetting to the factory defaultBasic menu operations Returning to the previousAdjusting the picture Adjusting the position TV-SYSTEMSystem PositionKeystone Clock PhaseZoom How to use Advanced Menu Input ResolutionDigital Cinema Reality BlankingRaster Position XGA ModeSxga Mode OPTION1 settings OPTION2 settings Lamp PowerFRONT/REAR DESK/CEILINGPassword FAN CONTROL2System Information FAN CONTROL1Setting the security Setting the network Connecting the PCSystem requirements Connection exampleUsing the serial terminals Pin assignments and signal namesCommunication conditions Factory setting Examples of connectionControl commands Cable specificationsConnecting to a PC Computer Projector DTE specifications Pin assignments and controlIndication of lamp monitor Cleaning and replacement of air filter Procedure of cleaningClean the air filter Dismantle the air filterTiming of lamp unit replacement Replacing the lamp unitLamp unit replacement steps Remove the two screws securing the fan unitLamp unit will be hot after it has been used Have a Phillips screwdriver ready ahead of timeSelect the lamp which has been replaced with the and buttons Using Web Browser Control Accessing from the Web browserPassword change Click OKMail set up button Power On/Off control Shutter controlChange password button Basic controlOK Normal operation Failed Occurrence of trouble Error informationMonitor information Mail setup When Failed has appeared for an item Parameter DescriptionMail setup page Continuing ErrorDNS server set up POP server setupButton to update settings Ping testContents of mail sent Adjust clockNetwork config Network statusUsing the PJLink protocol Supported commandsPJLink security authentication Command Control Description RemarksSymptoms Checks Power doesRemote control Not turn onSpecifications PT-D5600U PT-D5600UL PT-DW5000ULength of power supply cord Cabinet Outside dimensionsRemote control Power source Wireless mouse receiverCompatible Signal List PAL-M/PAL60 PAL/PAL-N/SECAMTrademark Acknowledgement DimensionsInstallation dimensions diagram Concernant LA Sécurité Précautions concernant la sécurité Ne pas couvrir le filtre et la sortie d’airNe pas surcharger la prise de courant Ne pas retirer le couvercle ou le modifierNe pas mettre d’objets étrangers dans le projecteur Ne pas placer le projecteur sur des surfaces instablesNe pas placer des récipients de liquide sur le projecteur ’utilisez pas un bloc lampe usagé Ne pas placer d’objets lourds sur le projecteur’utiliser que la pile indiquée Nettoyage et maintenance Précautions pour la manipulationPrécautions pour le transport Mise au rebutRemplacement de la lampe Période de remplacement de la lampePréparez un tournevis Phillips à l’avance Procédure de remplacement de la lampeLa lampe est chaude si elle vient d’être utilisée INIT. Compt Panasonic Canada Inc Panasonic Projector Systems CompanyTechnical Support

PT-DW5000UL specifications

The Panasonic PT-DW5000UL is a cutting-edge projection solution designed for professional use in various environments, including conferences, events, and large venues. Boasting a compact and lightweight design, this projector offers an impressive balance of high performance and portability, making it an excellent choice for users who require mobility without compromising on image quality.

At the heart of the PT-DW5000UL is its powerful DLP technology, which delivers stunning 5000 lumens brightness and a native resolution of 1920 x 1200 pixels. This outstanding resolution ensures that images are sharp, detailed, and vibrant, making it well-suited for displaying high-definition content, intricate graphics, and dynamic presentations. The projector’s high brightness level is particularly advantageous in well-lit environments, allowing for clear visibility even in challenging lighting conditions.

One of the standout features of the PT-DW5000UL is its advanced Solid Shine laser technology. This innovation eliminates the need for traditional lamps, resulting in a longer lifespan of up to 20,000 hours. This increase in operational longevity not only reduces maintenance costs but also ensures consistent performance over time. Moreover, the laser light source provides stable brightness and vivid colors throughout its lifespan, ensuring that every presentation looks its best.

The projector also incorporates a highly effective Dynamic Contrast feature, which enhances the depth of the images by adjusting light output automatically based on the content being displayed. This capability results in deeper blacks and brighter highlights, creating a more immersive viewing experience.

Connectivity is another significant characteristic of the PT-DW5000UL. It supports a wide range of inputs, including HDMI, DVI-D, and 5BNC, allowing seamless integration with various devices. Furthermore, the projector supports multi-screen and edge blending capabilities, making it suitable for large-scale presentations and installations that require multiple projectors to work in harmony.

For ease of installation, the PT-DW5000UL features a variety of lens options and a flexible lens shift range, enabling users to adjust the image position without distortion. This adaptability makes it suitable for different venue configurations, whether in an auditorium or an outdoor setting.

In conclusion, the Panasonic PT-DW5000UL stands out as a robust and reliable projector that combines advanced technology with user-friendly features. Its powerful brightness, exceptional image quality, and long-lasting performance make it an ideal choice for professionals seeking a versatile solution for their projection needs.
Top Page Image Contents