7. Use
•Carry out the required connections as described in chapter 5 and provide a power supply.
•Lift up the TFT display screen.
Switching the DVD player on and off
•Set the POWER switch 2% to the "ON" position to switch the DVD player on.
The TFT display screen switches on and the back- ground image appears.
If no disc is inserted into the disc tray the notice "READING" will appear briefly followed by the prompt "NO DISC".
•To switch the DVD player off set the POWER switch 2% to the position "OFF".
Operation
Buttons on the device and the remote control
Most of the functions described in this manual can be set using the buttons on the device or also the buttons on the remote control. When both buttons are possible for operation then both numbers will be specified after the button designation (for example DVD/USB/CARD button e 2*).
Display settings
• | Press the FUNCTION button 3# to access the | ||
| display settings. The settings can be accessed | ||
| at any time. |
|
|
• | Select with the navigation buttons | f 5! one | |
| of the inputs Brightness (Bri), Contrast (Con) and | ||
| Saturation (Sat). |
|
|
• | With the navigation buttons | f 5! change | |
| the value. |
|
|
•To exit the settings press the FUNCTION button 3# again.
•To reset the settings select the input Reset and press the OK button d ENTER 5@.
8. Menu functions
Navigating in the menu
1.Press the SETUP button s 3! to access the se-
tup menu. The main menu appears GENERAL SETUP PAGE.
• With the navigation buttonsf 5! and the OK button d ENTER 5@ you can carry out all settings in the menu.
* * GENERAL SETUP PAGE * *
TV DISPLAY | WIDE |
ANGLE MARK | AUS |
OSD LANGUAGE | GER |
CLOSED CAPTIONS | AUS |
SCREEN SAVER | EIN |
LAST MEMORY | AUS |
GOTO GENERAL SETUP PAGE
2. With the navigation buttons | you select a | |
menu by moving the yellow highlighting under | ||
the corresponding menu symbol. | ||
3. With the navigation buttons | you select an | |
input in a menu by moving the yellow bar over | ||
an input. |
|
|
4. With the navigation button | you change an | |
input in the sub menu and with the navigation | ||
button | you move back to the previous menu | |
level. |
|
|
5.To confirm a selection press the OK button d
ENTER 5@.
•All navigation possibilities in a current menu are displayed at the lower edge of the menu.
•To exit the setup menu either press the button SETUP s 3! or select the last symbol "EXIT SETUP" and press the OK button d ENTER 5@.
- 12 - |