Directed Electronics 359D manual Step

Page 13

warning! Verify that the vehicle is set to park and that the parking brake is set before beginning installation.

➜

step 1

Ground Wire

The BLACK wire on the main 8-pin harness is ground. This wire should be connected to a clean, paint-free area of metal in the drivers kick panel area. First strip back a ¾-inch section of the insulation off the BLACK wire and crimp a ring terminal (not provided) to that wire. Locate a clean, paint-free metal surface in the drivers kick panel. Using a self-tapping screw, drill the screw with the ring terminal to the metal area. Once screwed down, pull on the wire to ensure a good connection.

note: More problems are attributed to poor ground con- nections than any other cause. Take extra care to ensure the ground is clean and secure.

SELF-TAPPING

BOLT OR SCREW

GROUND

WIRE

	NOTE: REMOVE ANY PAINT	RING
DIA-591	BELOW RING CONNECTOR	CONNECTOR
10		© 2002 directed electronics, inc .

Image 13

Contents 359D Limited lifetime consumer warranty Important Note Table of contents Installation tools What is includedImportant information System maintenanceFcc/id notice Your warrantyDirected electronics, inc Directed electronics, inc Primary harness H/1, 8-pin connector Secondary harness H/2, 6-pin connectorRelay satellite thick gauge wires Relay satellite ribbon harness H/3, 5-pin connectorInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Directed electronics, inc Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Transmitter functions Standard configuration Transmitter/receiver learn routine Learn Routine will be exited if Locking/arming Using your systemUnlocking/disarming Ignition-controlled door locksRemote start Timer mode Valet take-over To perform Valet Take-Over Features menu Rapid resume logic TroubleshootingProgramming options Directed electronics, inc Directed electronics, inc Directed electronics, inc Security & convenience expansions Glossary of termsWiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc