Directed Electronics 359D manual Directed electronics, inc

Page 26

If the idle is too slow or too high, the system will shut down the engine to prevent damage. If the starter does not crank long enough to actually start the engine, it is possible to change the programming to extend the crank time. Refer to the Programming Options section of this guide.

On some vehicles the electrical system has too low of a voltage variance for the remote start module to see. In this case the engine will not be protected from over cranking, over revolution, or under revolution of the engine.

If this is the case, it will be necessary to locate a tachometer wire in the vehicle using the multi-meter. Identify the suspect wire according to the web information. Then start the vehicle with the key and place the black lead of the multi-meter on the nega- tive battery post and secure it. Put the multi-meter in the AC position and probe the suspect wire with the red lead of the multi-meter. With the engine at idle the multi-meter should read between .05 volts to 1.5 volts.

© 2002 directed electronics, inc .

23

Image 26
Contents 359D Limited lifetime consumer warranty Important Note Table of contents What is included Installation toolsSystem maintenance Important informationYour warranty Fcc/id noticeDirected electronics, inc Directed electronics, inc Secondary harness H/2, 6-pin connector Primary harness H/1, 8-pin connectorRelay satellite ribbon harness H/3, 5-pin connector Relay satellite thick gauge wiresInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Directed electronics, inc Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Transmitter functions Standard configuration Transmitter/receiver learn routine Learn Routine will be exited if Unlocking/disarming Using your systemLocking/arming Ignition-controlled door locksRemote start Timer mode Valet take-over To perform Valet Take-Over Features menu Programming options TroubleshootingRapid resume logic Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansionsWiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc