Directed Electronics 359D manual Directed electronics, inc

Page 24

Once the correct wire has been found, solder the small LIGHT GREEN wire off the main connector to it and cover the connec- tion with electrical tape.

Repeat this process for the unlock wire but press the switch to the unlock position when testing. Once you have identified the correct wire, solder the LIGHT BLUE wire off the main connector to it and cover the connection with electrical tape.

note: Additional parts may be required to interface with certain door lock types.

© 2002 directed electronics, inc .

21

Image 24
Contents 359D Limited lifetime consumer warranty Important Note Table of contents What is included Installation toolsSystem maintenance Important informationYour warranty Fcc/id noticeDirected electronics, inc Directed electronics, inc Secondary harness H/2, 6-pin connector Primary harness H/1, 8-pin connectorRelay satellite ribbon harness H/3, 5-pin connector Relay satellite thick gauge wiresInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Directed electronics, inc Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Transmitter functions Standard configuration Transmitter/receiver learn routine Learn Routine will be exited if Using your system Locking/armingUnlocking/disarming Ignition-controlled door locksRemote start Timer mode Valet take-over To perform Valet Take-Over Features menu Troubleshooting Rapid resume logicProgramming options Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansionsWiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc