Directed Electronics 359D manual To perform Valet Take-Over

Page 38

To perform Valet Take-Over:

1.Before turning off the engine, press and release and on the transmitter.

2.Turn the ignition key to the OFF position. The engine will stay running.

3.The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous Remote Start section for a complete list of shut-down inputs.)

note: This feature will not work if the brake pedal is being pressed.

© 2002 directed electronics, inc .

35

Image 38

Contents 359D Limited lifetime consumer warranty Important Note Table of contents What is included Installation toolsSystem maintenance Important informationYour warranty Fcc/id noticeDirected electronics, inc Directed electronics, inc Secondary harness H/2, 6-pin connector Primary harness H/1, 8-pin connectorRelay satellite ribbon harness H/3, 5-pin connector Relay satellite thick gauge wiresInstallation Step Constant Power and Ignition wires Meter, turn the key to the crank position and the voltage Accessory and Starter wires Directed electronics, inc Safety Shutdown Wires Directed electronics, inc Directed electronics, inc Directed electronics, inc Parking light flash Door locks Directed electronics, inc Engine monitoring Directed electronics, inc Directed electronics, inc Factory Alarm/Disarm Immobilizer Bypass Modules Transmitter functions Standard configuration Transmitter/receiver learn routine Learn Routine will be exited if Unlocking/disarming Using your systemLocking/arming Ignition-controlled door locksRemote start Timer mode Valet take-over To perform Valet Take-Over Features menu Programming options TroubleshootingRapid resume logic Directed electronics, inc Directed electronics, inc Directed electronics, inc Glossary of terms Security & convenience expansionsWiring quick reference guide Directed electronics, inc Directed electronics, inc Quick Reference Guide Company behind this system is Directed Electronics, Inc