Sharp DV-HR300H, DV-HR350H Setting the Remote Control Code, Setting the Manufacturer’s Code

VIDEO Plus+

CHANNEL Front display '/" panel

Operating a TV Using the

Remote Control

(Universal Remote Control)

The Universal Remote Control may operate the basic functions of 16 different types of TVs.

To enter the Manufacturer’s Code for your TV, follow the instructions below.

There is no guarantee that the universal remote control will function with your TV.

Setting the Manufacturer’s Code

1 Press OPERATE and CH ' of

TV CONTROL simultaneously.

2 Enter the 2-digit Manufacturer’s Code with the Number buttons (Ex. 02-“0”, “2”) within 10 seconds after releasing OPER- ATE and CH ' of TV CON-

TROL.

3 Point the remote control unit towards the TV and then press OPERATE of TV CONTROL.

•If the TV turns on/off, setup was successful. If not, repeat the proce- dure using another code.

See the list below for the Manufacturer’s Code and the buttons which work.

TV Brand	Manufacturer's Code
FERGUSON	07
GRUNDIG	06
HITACHI	13
ITT NOKIA	08
JVC	15
MITSUBISHI	16
PANASONIC 1	11
PANASONIC 2	12
PHILIPS	03
SANYO	14
SHARP 1	01
SHARP 2	02
SONY	09
THOMSON 1	04
THOMSON 2	05
TOSHIBA	10

TV function control

•TV Power: OPERATE

•TV Channel up/down: CH ' / "

•TV Volume up/down: VOL +/-

•TV-AV Selector: INPUT

NOTE

•If the batteries in the remote control unit are changed, the code settings must be re- entered.

•Some brands have more than one code listed above, due to changes in the codes. In such cases, try another code to find the code that operates your TV.

Major Components

Setting the Remote

Control Code

•Two types of remote control codes operate this Recorder: RC-1 and RC-2. If you operate this Recorder by remote control along with another SHARP DVD recorder or DVD player placed next to it simulta- neously, switching the remote control code (both the Recorder and remote control) to one of the signals (RC-1 or RC-2) will let you operate only with this Recorder.

•Make sure to set the Recorder and remote control to the same remote code. You can not operate the Recorder if they are not set to the same code.

Setting the Remote Con- trol Code of the Remote

Example: Setting the code to “RC-2”.

1 Press and hold OPERATE and 2 together for more than 5 seconds.

2 Press OPERATE of this Recorder

to see if you can turn it on/off.

•If you cannot, go to step 3.

NOTE

•The remote control code of the remote becomes “RC-1” when you change the batteries.

Setting the Remote Con- trol Code of the Recorder

3 Press OPERATE to turn off the Recorder.

4 Press and hold CHANNEL " and CHANNEL ' on the Recorder together for more than 5 seconds.

•Each time this operation is performed, the code of the Recorder toggles between “RC-1” and “RC-2”. The front panel display changes as the code changes.

•Press OPERATE on the remote control to see if you can turn on/off the Recorder.

If remote control does not work

Press OPERATE on the remote control and check the front panel display (RC-1 or RC-2). Set the remote control code according to the display and press OPERATE to see if you can turn on/off the Recorder.

21