Sharp DV-HR300H Recording to DVD, Setting Record End Time during Direct Recording, Press REC

2 Set a DVD-RW or DVD-R disc.

•When a new DVD-RW disc not

initialized yet is set, VR mode initializing starts automatically. When initializing is over, you can start recording.

• When you want to re-initialize in Video mode, select “DVD VIDEO MODE INIT.” screen (page 99).

• When you want to initialize in Video

VIDEO Plus+

mode from the beginning, select

“AUTO INITIALIZING” screen (page

99).

3 Press Number buttons or CH '/

"to select the channel to record.

4 Press REC MODE to select the desired recording mode.

• The recording mode changes as shown below each time the button is pressed.

FINE SP LP EP MNgg

•Recording mode set when “MNgg”

is selected is the recording mode set on the “MANUAL REC. MODE” screen (page 41).

5 Press ● REC.

•Recording begins and REC icon is displayed.

•The REC indicator (for DVD) on the front of the Recorder is lit red during recording.

DVD-RW

REC

VR OR I G I N AL

F I NE REMAIN 1h0m

1 / 1

1 / 1

0 0 : 0 0 : 0 1

6 Press REC PAUSE to pause recording.

•Pause will not function during timer recording.

•The REC indicator (for DVD) on the front of the Recorder blinks during Recording Pause mode.

7 Press REC PAUSE to resume recording.

8 Press REC STOP to stop recording.

•“DATA IS BEING RECORDED TO DISC.” displays on TV screen and recording stops.

•Stop recording first when you take out the disc.

Recording to DVD

NOTE

•Data is still written to the disc after recording is stopped, and so you may be unable to start the next recording immediately.

•Press ON SCREEN (under the cover) to confirm remaining time of DVD or check the counter display during recording.

•You cannot record programmes which prohibit recording.

•Recording either stops or pauses automati- cally in the following cases.

—Programme which prohibits recording is on air.

—Unable to continue recording for some reason.

•Timer recording cannot be performed

during direct recording. To perform timer recording, stop direct recording before the preset time for timer recording.

You may not be able to record on disc edited by other recorder.

•If a disc edited by other DVD recorder has more than 999 chapter marks, it cannot be edited (or recorded) with this Recorder.

•If a disc edited by other DVD recorder has added or erased scenes 51 times or more per title or the disc is protected, it cannot be edited (or recorded) with this Recorder.

About Recording to DVD in Video Mode

•In case you are recording to DVD in Video mode and recording stops due to power failure etc., recorded contents a few minutes before the stop may not be recorded.

•For details on limitation during recording in Video mode, see page 48 too.

Inserting Chapter Marks Manually during Recording

Press CHAPTER MARK (under the cover).

•“RECORDED CHAPTER MARK.” displays and chapter mark is recorded.

•You can only record chapter marks manually when recording to DVD-RW (VR mode).

•You cannot record chapter marks manually when recording to DVD-RW (Video mode) or DVD-R, or during Simultaneous Record- ing/Playback.

Setting Record End Time during Direct Recording

•You can set record end time during direct recording to DVD. For details see “Setting the Record End Time during Direct Recording (Simple Recording Timer)” on page 37.

39