Quick guide
Attaching the stand
Before performing work spread cushioning over the base area to lay the TV on, making sure the area is completely flat. This will prevent it from being damaged.
Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
1 Confirm the 3 screws supplied with the TV. | Soft cushion |
Screws (m3)
(used in step 3)
2 Insert the stand into the opening on the bottom of the TV. (1)
3 Insert and tighten the 3 screws on the bottom of the TV as shown. (2)
NOTE
• To detach the stand, perform the above steps in reverse order.
Alignment protrusions
Screw
Hex key
Setting the TV
Place the TV close to the AC outlet, and keep the power plug within reach.
Ferrite Core*
Standard DIN45325 plug (IEC
AC cord
Cable clamp
Product shape varies in some countries.
Antenna
Connect the antenna cable from your
An indoor antenna can also be used under good reception conditions. Passive and active room antennas are offered commercially. In an active antenna its power is supplied via the antenna input terminal.
The supply voltage (5V) must be correspondingly set under “Supply Voltage”. (Page 16)
* Ferrite Core
The Ferrite Core should be permanently attached and never removed from the AC cord.
The AC cord is supplied either with a ferrite core or without a ferrite core. Neither type causes unnecessary electrical wave emissions or interference.
3