Sharp 60LE920UN, 52LE920UN service manual Space

LC-52LE920UN/LC-60LE920UN

[4] How to replace the touch key sensor PWB

1.Replace the touch key sensor PWB in a clean room.

Be sure to remove the dust from the unit before carrying it into the clean room.

2.Remove the touch key sensor PWB from the front glass.

3.Clean the bonding surface with alcohol.

Depending on the dirt, water solution of 80%vol can be effective.

4.Adhere a spacer before bonding the touch unit.

Product Manual Touch Sensor with ITO (Transparent Electrode)

Pull tap of double-sided tape Pull tap of protective sheet

i)Remove the touch sensor from the front glass.

*When peeling the ITO section, check that there is no glue residue on the front glass.

If glue residue, dirt, fingerprints, etc. are found, wipe them off with anhydrous alcohol.

Do not apply anhydrous alcohol to the double-sided tape on the metal part attaching to the glass.

ii)Adhere the spacer to the back of the FPCB section.

i	f.j Space
	Release paper

ii-1. Peel the release paper of the double-sided tape on the FPCB section.

ii-2. Adhere the spacer to the FPCB section. (Use the right and upper sides of the FPCB section as a reference.)

*Check that the spacer does not contact with the ITO section.

!E

4-13