Sharp 60LE920UN Factory setting, Software version, Writing the inch and model name onto Eeprom

LC-52LE920UN/LC-60LE920UN

11. Factory setting

After completing the factory setting, pull out the AC cord to complete the setting.

CAUTION: Do not turn on the power after completinq the factory settinq. If the power is turned on, confiqure the factory settinq aqain.

Adjustment point	Adjustment conditions						Adjustment procedure
1 Factory setting	Complete the setting by	• Point the cursor to [INDUSTRY					INIT], set	to "ON" using [+]/[-] of the [VOL] key, and press
	pulling out the AC cord.	the	[ENT]	key.
		The version confirmation screen appears on the green screen. It is completed when [SUC-
		CESS] is displayed at the top.
		(if error occurs, [ERROR] is displayed on the red screen.)
		• Turn off the AC power.
		The following items are initialized when configuring the factory setting.
		1)	User set value
		2)	Channel		data (broadcasting		frequency,	etc.)
		3)	Password		setting	value
		4)	Operating		time
		5)	StandbyCause
		6)	Auto installation			flag
		7)	V-CHIP	block setting value

12. Software version

1.Main microcomputer

2.Monitor microcomputer

3.EDID data (Analog RGB)

4.(Reference: File name in the Technical Department)

For analog RGB Input3: IC509: edid_dsub15_fullhd v6 256.BIN

13.Writing the inch and model name onto EEPROM

Writing method

1.Pull out the AC cord.

2.Copy the application for writing inch/model name (HLI2MA01 .USB) and model/inch file (52LE920.MDL) to the USB memory.

3.Hold down the power button and insert the AC cord.

4.Release the power button after 5 seconds.

5.Update starts.

LE920 The inch and model name are displayed.

UPGRADE SUCCESS

6.Pull out the AC cord. Model/inch file

52LE920.MDL

60LE920.MDL

*32 inch is not necessary.

NOTE: When replacing the main PWB, make sure to perform the writing the inch and model name onto EEPROM

5-14