Sharp 60LE920UN, 52LE920UN service manual Video input signal, Component 15K

LC-52LE920UN/LC-60LE920UN

[] Signal generator level adjustment check (Adjust to the standard value level.)

• Composite signal:
• 15K component	signal:	Y level:
		PB/PR	level:
• 33K component	signal:	Y level:
		PB/PR	level:
• Analog RGB:		RGB level:

0.714Vp-p + 0.02Vp-p (Pedestal to white) 0.714Vp-p+ 0.02Vp-p (Pedestal to white) 0.7Vp-p + 0.02Vp-p

0.7Vp-p + 0.02Vp-p (Pedestal to white) 0.7Vp-p + 0.02Vp-p

0.7Vp-p + 0.02Vp-p (Pedestal to white)

8.2.2 Process mode

Adjustment point	Adjustment conditions	Adjustment	procedure
Process mode		Enter the process adjustment mode using	the process adjustment remote control.

8.2.3 Composite N358 signal/tuner adjustment

Adjustment point	Adjustment conditions
1 Setting	N358 signal
	US-10ch

Adjustment procedure

•Send the N358 color bar (color saturation: 75%) signal to the Video 2 video input.

•Send the in-house signal (use US-10ch) to TUNER.

[Video input signal] [In-house US-10ch]

Color saturation: 75%

1`100% white 1"0% black 1"100% white

2	Automatic adjustment		exe-		Point	the cursor	to [111N358ALL ADJ(INPUT2)]		and press	the [Enter] key.
	cution				The adjustment		is complete when [mN358	ALL ADJ(INPUT2) OK] is displayed.
8.2.4	Component	15K	signal	adjustment
	Adjustment	point		Adjustment conditions			Adjustment	procedure
1	Setting			480i signal	,Send	the 100%	color bar signal to the Video		1 component	input.

								100% color bar
								480i
						1" 100%	white	1"0% black
2	Automatic adjustment		exe-		Point the cursor to [mCOMP15K			ADJ(INPUT1 )] and press	the	[Enter] key.
	cution				The adjustment	is complete	when	[1!1COMP15K ADJ(INPUT1)		OK] is displayed.
8.2.5	COMPONENT	33K	signal	adjustment
	Adjustment	point		Adjustment conditions			Adjustment procedure
1	Setting			1080i signal	,Send the 100%	color bar	signal	to the Video 1 component	input.

Color saturation: 100% 1080i

__	100% color bar
1" 100% white	1`0% black

2 Automatic adjustment exe-	Point the cursor to [mCOMP33K	ADJ(INPUT1)]
cution	The adjustment is complete when	[mCOMP33K

and press the [Enter] key. ADJ(INPUT1 ) OK] is displayed.

5-10