RCA 15491880 manual Using the WHO.INPUT Button, To turn off all RCA, GE

To turn off all the

RCA, GE, and

PROSCAN components that are connected to the TV, press ONoOFF twice

within two seconds.

Th_ _ature on_

works with mostRCA, GEandPROSCAN

produc_.

Using the Remote Control

PAUSE If you're operating a VCR or DVD Player with the remote control, press PAUSE when the disc or videotape is playing to pause playback.

PLAY If you're operating a VCR or DVD Player, plays tl_e disc or videotape.

REC*¥CR+ When the GUIDE Plus+ program guide is on the screen, press REC-VCR+ to program your VCR to record it program. If tile remote is in VCR mode. press REC°VCR+ to start recording

REVERSE If you're operating a VCR or DVI) Player with the remote control, press REVI_RSE to go backwards on a disc or videotape.

SAT°CABLE Puts the remote in SAT°CABLE mode. If you set up the Auto Tuning lOature (Chapter 3), pressing the SAT*CABLE button automatically tunes the TV to the correct channel.

SKIP If you press this button before you change the channel, the TV waits 30 seconds and automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if you press SKIP txxo times before you change tl_e channel, the TV waits 60 seconds and automatically turns back to the original channel).

SOUND Displays the AUDlO PROCESSORmenu.

STOP If you're operating a VCR or DVD Player, stops playing the disc or videotape.

'IV Turns on the TV and puts the remote in TV mode. Also displays channel information.

YER1 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR1 button automatically tunes the TV to the correct channel.

VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR2 button automatically tunes the TV to the correct channel.

VOL (up and down) buttons Decrease or increase the TV's volume.

WHO-INPUT In TV mode, press WHO-INPUT to toggle through the available Video Input channels (VID/SVID and the current channel). In SAT mode, press to select available channel lists.

Using the WHO.INPUT Button

Use the WHO-INPUT button to toggle through the available input sources (VID and the current channel) and view the content from the component you have connected to the TV.

1.Press TV to place the remote in TV mode. Make sure that the content from the component is turned ON.

2.Press WHO-INPUT to tune to the available input source and view the component.

3.Press WHO.INPUT again to rune back to the channel you were previously watching.

Chapter 2 23