Using the Remote Control
Using Direct Entry
1.Turn on the component you want tile remote to operate.
2.Look tip tile brand and code nuh_ller(s) for the component on tile code list on page 26.
3.Press and hold the component button that corresponds to the component you want the remote to operate (VCR1, DVD, etc.)
4.Enter the code Dora the code list.
5.Release tile component button.
6.Press ON*OFF to see if tile component responds to tile remote conlnlands. If it doesn't, try pressing tile component button and then
7.If you get no response, repeat these steps using the next code listed for your brand until tile component responds to tile remote conlnlands.
The buttons might
operate differently for
other components,
especially when you're
using another eomponent's menu system.
How to Use the Remote After You've
Programmed It
Once the remote has been programmed successfully, you are ready to use it to control your components. To operate the component:
1.Press tile component button (TV, VCR1, VCR2, DVD, AUX, or
2.Press
3.Use the remote buttons that apply to that component.
Note: If you keep pressing buttons and nothing happens, the remote is probably in the wrong *node. You must press the component button that matches the component you want to operate (i.e., if you want to operate the VCR, press VCR1 on the remote control to put the remote in VCR mode.)
Chapter 2 | 25 |