Panasonic DMR-E100H warranty FCC Note, Before moving the unit, ensure the disc tray is empty

Page 2

Getting started

CAUTION!

THIS PRODUCT UTILIZES A LASER.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORM- ANCE OF PROCEDURES OTHER THAN THOSE SPECI- FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

DO NOT OPEN COVERS AND DO NOT REPAIR YOUR- SELF. REFER SERVICING TO QUALIFIED PERSONNEL.

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PRODUCT DAMAGE, DO NOT EXPOSE THIS APPARATUS TO RAIN, MOIS- TURE, DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of suffi- cient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the ap- pliance.

CAUTION:

TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

CAUTION!

DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT-IN CABINET OR IN ANOTHER CONFINED SPACE. ENSURE THE UNIT IS WELL VENTILATED. TO PREVENT RISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TO OVERHEATING, ENSURE THAT CURTAINS AND ANY OTHER MATERIALS DO NOT OBSTRUCT THE VENTILATION VENTS.

Keep the SD Memory Card out of reach of children. If swallowed, seek medical advice immediately.

THE FOLLOWING APPLIES ONLY IN THE U.S.A.

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

≥Reorient or relocate the receiving antenna.

≥Increase the separation between the equipment and receiver.

≥Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

≥Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, follow the attached installation instructions and use only shielded inter- face cables when connecting to peripheral devices.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s author- ity to operate this equipment.

This device complies with Part 15 of the FCC Rules. Opera- tion is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

THE FOLLOWING APPLIES ONLY IN THE U.S.A.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the build- ing, as close to the point of cable entry as practical.

DANGER

- VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN.

 

AVOID DIRECT EXPOSURE TO BEAM.

(FDA 21 CFR)

CAUTION

- VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN.

 

AVOID EXPOSURE TO BEAM.

(IEC60825-1)

ATTENTION- RAYONNEMENT LASER VISIBLE ET INVISIBLE EN CAS D’OUVERTURE.

 

EXPOSITION DANGEREUSE AU FAISCEAU.

 

ADVARSEL - SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING.

 

 

UNDGÅ UDSÆTTELSE FOR STRÅLING.

 

VARO!

- AVATTAESSA OLET ALTTIINA NÄKYVÄÄ JA NÄKYMÄTÖN

 

 

LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.

 

VARNING

- SYNLIG OCH OSYNLIG LASERSTRÅLNING NÄR DENNA DEL

 

ÄR ÖPPNAD. BETRAKTA EJ STRÅLEN.

 

ADVARSEL - SYNLIG OG USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES.

UNNGÅ EKSPONERING FOR STRÅLEN.

VORSICHT - SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG, WENN ABDECKUNG

GEÖFFNET. NICHT DEM STRAHL AUSSETZEN.

-

- RQLS0233 (Inside of product)

Before moving the unit, ensure the disc tray is empty.

Failure to do so will risk severely damaging the disc and the unit.

Do not place the unit on amplifiers or equip- ment that may become hot.

The heat can damage the unit.

2

RQT6986

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Warranty can be found on ExampleFollowing Applies only in the U.S.A FCC NoteBefore moving the unit, ensure the disc tray is empty RQLS0233 Inside of productFeatures Table of contents AccessoriesComponent Video OUT terminal Antenna and television connectionsVideo OUT terminal Use Remote controlBatteries Do notAdding and deleting channels If Plug-in Auto Tuning failsPress 3, 4 to select Antenna Sys Tem and press Enter Cancel VCR Plusi guide channel settingsPress 3, 4 to select VCR Plusr CH Setting and press Enter Station Guide Channel Channel settingPress 3, 4 to select TV Screen and press Set up to match your televisionTelevision operation Press 3, 4 to select TV Type and press EnterDiscs that cannot be played Disc informationDiscs you can use for recording and play Play-only discs Discs you can useHDD Hard disk drive SD/PC cardControl reference guide Remote controlPower button Í, DVD Power 100Main unit Unit’s displayPress OPEN/CLOSE to open the tray and insert a disc left Press REC Mode to select the recording mode nextRecording television programs Inserting discsWatching the television while recording Press Functions Recording from a video cassette recorderDV Automatic Recording DV Auto REC Press 3, 4, 2, 1 to select DV Auto REC and then EnterReviewing the recorded images while recording-Time Slip Playing while you are recordingSimultaneous rec and play Playing discs Press OPEN/CLOSE to open the tray and insert a discPosition Memory When a menu screen appears on the televisionUsing the Direct Navigator Other methods of play Quick View Skipping a minute forward-CM SkipSelecting an amount of time to skip -Time Slip Marking places to play again-MARKERPress 3, 4 to select the folder and press Enter Playing still pictures and SD Video MPEG4 programsPress 3, 4 to select Input and press Enter Press 3, 4 to select the drive and press EnterTo play SD Video MPEG4 programs Press 3, 4 to select Slide Show and press EnterPress 3 To select Play Press Enter DVD- Jpeg RAMPress 1 to display the tree screen Using menus to play MP3 discsPress TOP Menu Press 3, 4, 2, 1 to select a group and press EnterWhile playing HDD, DVD-RAM or Video CD Changing audioPress Audio While playing DVD-Audio or DVD-VideoSpecify a time to stop recording Timer recordingUsing VCR Plusr codes to make timer recordings Manually programming timer recordings Press 3, 4 to select on and then Enter Auto Renewal RecordingPress 3, 4 to select the program and then Enter Check programsPress 3, 4 to select the program Change or cancel the programPress Cancel or ADD/DLT to delete Or press Enter to changeSelect items for dubbing Select the recording modeDubbing programs or play list Select the dubbing directionPress 2, 1 to select Yes and press Enter One Touch DubbingPress Dubbing Capacity for SD Video MPEG4 programsPress Enter at the end point Creating play listsPress Enter at the start point Press 3, 4 to select Exit and press EnterTo erase a play list or a play list scene during playback Playing play listsPlaying play list scenes Editing play lists Erase MoveRe-edit Editing programs Press 2, 1 to set protection and press Enter Press 2, 1 to Select ErasePress Enter Enter atEditing still pictures Select the copying drive Press 3, 4, 2, 1 to select a still picture and press EnterPress 3, 4, 2, 1 to select Copy and press Enter To erase check marksPrint Dpof Settings FormatProtect FunctionsreturnPress 3, 4, 2, 1 to select Erase and press Enter Press 3, 4, 2, 1 to select Set Up or Cancel and press EnterPress Enter to complete Procedure Press 2, 1 to select Yes and press EnterEditing SD Video MPEG4 programs Press Enter To complete Press 2, 1 toSelect Yes Select Start Press 2 Press 2, 1 toPress 3, 4 to select Item and press HDD, Disc settingDisc Protection Select First playProtection and press To complete Press Press Enter ProcedurePress 2, 1 to set disc Press Press 2 Press 2, 1 toPress 3, 4, 2, 1 to select the character and press Enter Using the numbered buttons to enter charactersEntering text To erase a characterPress Status On-screen displaysChanging the information displayed Display examplesDisc menu Using on-screen menusCommon procedures Press 3, 4 to select the menuVideo menu Play menuAudio menu On nextWhen User is selected 3D NRSet Up Changing the unit’s settingsSummary of settings ChannelVideo AudioDTS DisplayScreen Audio channel for DV input Press Setup to show the menusPress Setup Tabs Menus OptionsPress 3, 4 to select Auto Clock Setting and press Enter Clock settingsPress 3, 4 to select Manual Clock Setting and press Enter Press 3, 4 to select Time Zone Adjust and press EnterPress Other channel settingsPress 3, 4 to select Channel Enjoying CATV/Satellite broadcasts Enjoying more powerful soundHome Theater Two cable TV boxes Connecting a cable TV box/satellite receiverOne cable TV box/satellite receiver Connecting an amplifier or system component Recording to digital recording equipment or cassette tapesConnecting other video equipment Other antenna connection from the unit to the television Other antenna connectionsOther antenna connection to the unit Glossary How to hold a disc or CardHandling precautions Disc handlingOn the unit’s display Error messagesOn the television Troubleshooting guide Will be the front two speakers only SionMaintenance DVD-RSpecifications DMR-E100H Limited Warranty only for U.S.APanasonic DVD Recorder Limited Warranty User memoPanasonic Canada Inc Limited Warranty only for CanadaProduct Service Product informationPara disfrutar del vídeo progresivo Guía de referencia rápida en españolConexiones del televisor y de la antena PreparaciónPulse ¥, REC para iniciar la grabación Pulse REC Mode para seleccionar el modo de grabaciónGrabación de progr amas de televisión Reproducción de discosIndex Electric Corporation of America Puerto Rico, Inc. PSC
Top Page Image Contents