Pelco TLR2096 operation manual Troubleshooting, SELF-DIAGNOSTIC Function and Warning Display

12.0TROUBLESHOOTING

12.1SELF-DIAGNOSTIC FUNCTION AND WARNING DISPLAY

The VCR uses self-diagnostics to detect internal malfunctions during recording. If one occurs, the VCR indicates it on the monitor and in the VCR’s fluorescent dis- play.

Table J shows the type of malfunction corresponding to the warning display and the action to take.

Table J. Warning Display and Actions

Fluorescent	Monitor	Cause	Remedy	To turn off the indication
display
End	TAPE END	THE TAPE ENDS DURING	Rewind the tape and press	Turn off the indication on the fluorescent
		RECORDING	the EJECT button.	display and on the screen by pressing the
				EJECT button or rewinding the tape.
—	NO SIGNAL	LACK OF VIDEO SIGNAL	Check for loose connec-	When a video signal is restored or the
		INPUT (NOTE 1)	tions.	record mode is cleared, the indication on
				the screen turns off.
—	CHECK	TAPE/ DECK TROUBLE	First, check the cassette. If there seems to be nothing wrong with the
			cassette, try the recording operation again. If the indication "CHECK" is
			still displayed, change the cassette with a new one and try the operation
			again. Otherwise, unplug the power cord and contact your dealer.

•Lack of video input signal.

If the VCR is set to record and it does not detect an input signal, NO SIGNAL appears on the monitor and the call signal is output from the rear terminal.

Check that the cable from the camera is not broken and the camera’s power has not been lost.

48 Pelco Manual C651M (7/99)