Sylvania LD190552 owner manual Watching TV, Time by 30 minutes up to 120 minutes

14

WATCHING TV

Sleep Timer

can set the unit to go into standby mode after an incremental period of time.

Press SLEEP repeatedly to change the amount of time (increases	Sleep	120min.
the time by 30 minutes up to 120 minutes).

Press SLEEP once to call up the display for checking the remaining time.

• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is displayed.

Switching Each Input Mode can easily switch with the remote control between TV (ATSC or NTSC) and external devices when they are connected to the unit.

Press INPUT SELECT or CH ▲ repeatedly to cycle through the input modes.

Input Select

TV

VideoHDMI1

ComponentHDMI2

HDMI1Component

HDMI2Video

PC

e.g.)

11-1 Video Component

DTV /TV channel

PCHDMI2HDMI1

• Pressing CH ▼ reverses the direction of the input modes.

Channel Selection

Select channels by using CH ▲/▼ or the Number buttons.

• To select the memorized channels, use CH ▲/▼ or the Number buttons.

• To select the non-memorized channels,11-1use the Number buttons.

To use the Number buttons

ATSC

- When selecting digital channel 11−1

Be sure to press − before entering the subchannel number.

NTSC

- When selecting cable or analog channel 11

Press CH RETURN to return to the previously viewed channel.

Note	•	[No Signal] will appear on the TV screen after the subchannel
		broadcast is over.
	•	[Audio only program] message will appear on the TV screen, when you
		receive only sound signal.

Still Mode can freeze the image shown on the TV screen for 5 minutes.

Press PAUSE F to freeze the image.

Still

•The sound output will not be paused.

•To cancel freeze mode, press any buttons except POWER.