Sylvania LD190552 owner manual Autoprogram, Removed as well, Will be canceled, Change PIN. p.23

Channel

Before you begin:

Make sure the unit is connected to antenna or cable.

1 Use ▲/▼ to select the item you want to adjust, then press

ENTER.

Picture	Channel
Sound	Autoprogram
	Channel List
Channel	Add Channels
	Antenna
Features
Language
DVD

2 Adjust the following items.

Autoprogram

If you switch wires (e.g. between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you restore the DTV channels you deleted, it is recommended to use Autoprogram to perform a new channel search.

1 Use ▲/▼ to select [Autoprogram], then press ENTER. 2 Use ▲/▼ to select an appropriate option, then press

ENTER.

					English			19
								INTRODUCTION
Note
•	After setting [Autoprogram], using CH ▲/▼ on the remote
	control skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact
	the Cable provider.
• If you press POWER or SETUP during autoprogram, the setting
	will be canceled.
• Even if [Autoprogram] is completed, the channel setting will be
	lost if the AC power cord is unplugged before the unit goes into							PREPARATION
	standby mode by pressing POWER.
•	The PIN code will be required once you set a PIN code in the
•	[Child Lock]. ➠ p.21
	If you want to change your PIN code, follow the instruction of
	[Change PIN]. ➠ p.23
Channel List
The channels selected here can be skipped when selecting the								WATCHING TV
channels using CH ▲/▼.
Those channels can still be selected with the Number buttons.
1 Use ▲/▼ to select [Channel List], then press ENTER.
2 Use ▲/▼ to select the channel you want to remove, then
	press ENTER.							USING
			Channel List					FUNCTIONS
		Picture
						DTV	6-1
		Sound
			Highlight channels for			DTV	8-1
		Channel	Ch Up / Down key selection.				9
							27
		Features				DTV	48-1	OPERATING
							58
		Language				DTV	67-1
		DVD	Ch Select	ENTER	Watch / Skip		Back
								DVD
	• The channel display for the removed channel darkens.

Picture

Sound

Channel

Features

Language

DVD

Autoprogram

Auto program will rescan all channels. Auto programming may take more than 20 minutes to complete.

Select your signal source.

Antenna

Cable Or

ANT.IN

Back

Antenna

Cable

You will not be able to select the channel again using
CH ▲/▼.
	CONNECTING
• To reactivate a removed channel, use ▲/▼ and press
ENTER.The registered channels are highlighted.
• When you remove a main channel, its subchannels are
removed as well.
	DEVICES
Note
• The channel with the [DTV] indicated on the display is ATSC.
Otherwise the channel is NTSC.

•When connected to VHF/UHF antenna, select [Antenna].

•When connected to CATV, select [Cable].

•[Autoprogram] will begin.

Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.

75%

Digital channels		10 ch
Analog channels		6 ch
	Exit

USEFUL TIPS

INFORMATION

•When the scanning and memorizing are completed, the lowest memorized channel will be displayed.