8
Supplied Accessories
Owner’s Manual | Quick Start Guide Registration card | |||
|
|
|
|
|
|
|
|
|
|
Quick
Start
Installation
Installation
Instalación
Attaching the Base
You must attach the base to the unit to have it as a table top unit. Be sure the front and rear of the base match the proper direction.
1 Spread a thick and soft cloth over a table as shown at step 2. Place the main unit face down onto it. Make sure not to damage the screen.
Remote Control (NF033UD) Batteries
(AA, 1.5V x 2)
AA
AA
TV base and 3 screws (M4 x 12)
2 Insert 2 hooks under the | ➁ |
bottom of the main unit into |
|
base holes. (shown by arrow |
|
➀), then move the base in | ➀ |
the direction as shown by |
arrow ➁ until it stops and the screw holes are aligned. Make sure not to put the AC power cord between the base and the unit.
Note
•If you lose the screws, please purchase M4×12 Phillips head screws at your local store.
•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.
When using a universal remote control to operate this unit.
•Make sure the component code on your universal remote control is set to our brand. Refer to the manual accompanying your remote control for more details.
•We do not guarantee 100% interoperability with all universal remote controls.
Mounting the Unit on Your Furniture
Screw this unit on your furniture tightly using wood screws (not supplied) in the 2 holes at the back of the base as shown.
•Recommended screw dimension : 0.201 x 0.788 inches(5.1 x 20 mm) rear of this unit
screw holes
Note
•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.
Tilt Stand | 10° | ||
You can adjust the stand to | |||
|
| ||
change the angle of the unit |
|
| |
|
|
3 Drive Phillips head screws into the 3 threaded holes at the bottom of the base until they are tight.
To remove the base from this unit
•Unscrew the Phillips head screws in step 3.
After the screws are removed, move the base in the opposite direction as shown by arrow in step 2, then pull the base up toward the rear of the unit. Be careful not to drop the base when you remove it.
Note
•When attaching the base, ensure that all screws are tightly fastened. If the base is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
•When attaching the base, ensure that FRONT ↑ written on the base is upward. If it’s not upward, the 2 hooks don’t fit in the base.
Installing the Batteries
Install the batteries (AA, 1.5V x 2) matching the polarity indicated inside battery compartment of the remote control.
Battery Precautions:
•Be sure to follow the correct polarity as indicated in the battery compartment. Reversed batteries may cause damage to the device.
•Do not mix different types of batteries together (e.g. Alkaline and
•If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
•Do not try to recharge batteries; they can overheat and rupture.