Sylvania 6632LCT owner manual Watching TV Channel Selection, Volume Adjustment, Ntsc, Atsc, Mute

WATCHING TV

CHANNEL SELECTION

You can select the channel by using either [CH K/L] or Channel number buttons. How to select the channel in each way is shown below.

POWER	SLEEP	INPUT
		SELECT

1	2	3
4	5	6

NTSC

CH4

18:00

18:30

19:00

19:30

20:00

ATSC

CH4-1No signal No signal

CH4-1 CH4-2 CH4-3

CH4-1 No signal CH4-3

CH4-1 CH4-2 No signal

7	8	9	AUDIO
			STILL
-	0
SETUP			SCREEN
			MODE
		ENTER
BACK			INFO
	CH RETURN
VOL.		MUTE	CH

1Using [CH K/L] or Channel number buttons, and pressing [ENTER].

•Using [CH K/L], change the channel.

•When you select a channel press the channel number you want to view with Channel number buttons. The selected channel will be displayed.

•When selecting analog channel 12

1 2 ENTER

•When selecting digital channel 12-1

Be sure to press [–]before entering the minor-channel number.

1 2 - 1 ENTER

•If the channel broadcasts NTSC and ATSC both and you don't press [–], then you will receive the NTSC channel only. The moment you press [–], the memorized smallest digital channel will be displayed.

•When you press [CH RETURN], the previously selected channel will be selected.

•Same operation is available with [CHANNEL K/L] on the top panel of the main unit.

NOTE:

In the DTV broadcasting, one channel sometimes broadcasts multiple programs depending on the air time. In this case, the main channel is called major channel and the minor-channel is called minor channel.

: changes automatically

: change manually by pressing [CH /] on your remote control.

NOTE:

“No signal” will appear on the screen after the minor- channel broadcast is over.

You will need to change the channel to continue watching another TV program.

VOLUME ADJUSTMENT

This section describes how to adjust the volume when viewing TV. The MUTE function, which is use- ful when you have a visitor or a phone call, will be also described.

BACK INFO

	CH RETURN
VOL.	MUTE	CH

1Using [VOL. X/Y] or [MUTE] [VOL. X/Y]

•You can adjust the audio volume with [VOL. X/Y].

•The volume bar is displayed at the bottom of the screen when adjusting the volume.

•Same operation is available with [VOLUME X/Y] on the top panel of the main unit.

Volume 20

•The volume bar display will automatically dis- appear in a few seconds.

[MUTE]

•Press [MUTE] on the remote control to mute the sound.

•To release the Mute status, press [MUTE] again or press [VOL. X/Y].

Mute

About minor-channel broadcasting:

There may be different programs being broad- cast on minor-channels through a single chan- nel from ATSC. You can watch each minor- channel program being broadcast by selecting one of the minor-channels.

•“Mute” is displayed on the screen for a few sec- onds.

18

EN