Actiontec electronic 56K manual Declaration of Conformity

Page 31

Notices

Declaration of Conformity

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harm- ful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio and television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

lReorient the receiving antenna.

lIncrease the separation between the equipment and receiver.

lConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

lConsult the dealer or an experienced radio/TV technician for help.

CAUTION: CHANGES OR MODIFICATIONS NOT EX- PRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian main- tenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunica- tions company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connec- tions of the power utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

31

Image 31
Contents Page Table Of Contents Contacting Actiontec Customer Support Product Registration Safety InformationPage Package Contents Product FeaturesFor Windows 95/98/NT Installing the ModemHardware Installation System PreparationRemoving the Backplate Page Configuring Windows Device Driver Installation and ConfigurationConfiguring Windows 95 OSR2 Configuring Windows Configuring Windows NT Page Found V.90 PCI Data/Fax Modem Port FC00 IRQ# Configuring DOS and WindowsWindows Apmdmcfg enter Configuring OS/2 WarpDEVICE=C\OS2\MDOS\VCOM.SYS Configuring UnixWareConfiguring the Modem For Linux Verified for Red Hat 5.2 # mknod /dev/ttyS4 c 4 # mknod /dev/cua4 c 5 Setting up and using PPP Setting Up and Using PPP Minimal Setup Configuring And Using kppp Using the Gnome Dialer AppletSetting Up and Using The linuxconf Dialer Some General Tips Configuring Your Modem’s Country Code S38 Default 56K Dial Line Rate AT Commands Affecting ITU-T V.90 OperationExamples S109 default K56flex and V.90 SelectionCommunications software does not work Help and Service InformationNo dial tone error Nothing appears on the screen when I type In terminal modeCan’t Connect at 56K Rates Open COM Port Error Message in W indows 95/98/NTReconfiguring a Windows Dial-Up Networking Connection Declaration of Conformity FCC Part 68 Requirements Telecommunications RegulationsIndustry Canada Class B Emission Compliance Statement
Related manuals
Manual 33 pages 1.47 Kb