Actiontec electronic 56K manual Telecommunications Regulations, FCC Part 68 Requirements

Page 32

Telecommunications Regulations

The following three statements are provided in accordance with the Federal Com- munications Commission (FCC) and CDOC (Canada) regulations. Please read these statements carefully before installing your modem.

FCC Part 68 Requirements

This equipment complies with Part 68 of the FCC Rules. On the bottom of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be given to the telephone company.

The REN is used to determine the maximum number of devices connected to your telephone line that will ring in response to an incoming call. In most, but not all, areas, the total REN of devices connected to a line should not exceed five (5.0). To find out the total permitted in your area, contact your local telephone company.

If your telephone equipment causes harm to the telephone network, the telephone company can discontinue your service temporarily. If possible, the company will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company can make changes in its facilities, equipment, opera- tions, or procedures that could affect the operation of your equipment. If so, you will be notified in advance so you can make the changes needed to maintain unin- terrupted service.

If you experience trouble with this equipment, please contact the manufacturer at the address given in this manual. The telephone company may ask that you dis- connect this equipment from the network until the problem has been corrected or until you are sure that the equipment in is not malfunctioning.

Canadian Department Of Communications (CDOC) Certification La- bel:

NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommu- nications network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment

32

Image 32
Contents Page Table Of Contents Contacting Actiontec Customer Support Safety Information Product RegistrationPage Product Features Package ContentsInstalling the Modem Hardware InstallationSystem Preparation For Windows 95/98/NTRemoving the Backplate Page Configuring Windows 95 OSR2 Device Driver Installation and ConfigurationConfiguring Windows Configuring Windows Configuring Windows NT Page Configuring DOS and Windows Found V.90 PCI Data/Fax Modem Port FC00 IRQ#Windows Configuring OS/2 Warp Apmdmcfg enterConfiguring UnixWare DEVICE=C\OS2\MDOS\VCOM.SYSConfiguring the Modem For Linux Verified for Red Hat 5.2 # mknod /dev/ttyS4 c 4 # mknod /dev/cua4 c 5 Setting up and using PPP Setting Up and Using PPP Minimal Setup Using the Gnome Dialer Applet Configuring And Using kpppSetting Up and Using The linuxconf Dialer Some General Tips Configuring Your Modem’s Country Code AT Commands Affecting ITU-T V.90 Operation S38 Default 56K Dial Line RateS109 default K56flex and V.90 Selection ExamplesHelp and Service Information No dial tone errorNothing appears on the screen when I type In terminal mode Communications software does not workOpen COM Port Error Message in W indows 95/98/NT Can’t Connect at 56K RatesReconfiguring a Windows Dial-Up Networking Connection Declaration of Conformity Telecommunications Regulations FCC Part 68 RequirementsIndustry Canada Class B Emission Compliance Statement
Related manuals
Manual 33 pages 1.47 Kb