Actiontec electronic 56K manual

Page 9

Step 6 Put the chassis cover back on the computer.

Step 7 Be sure that all power switches are in the OFF position, then reconnect the power cables to the computer and its peripherals.

Step 8 Connect the telephone line cable to the Line (Telco) jack on the back of the modem.

Step 9 Turn on the computer and proceed to the following sections to configure your modem to the operating system you are using.

9

Image 9

Contents Page Table Of Contents Contacting Actiontec Customer Support Product Registration Safety InformationPage Package Contents Product FeaturesHardware Installation Installing the ModemSystem Preparation For Windows 95/98/NTRemoving the Backplate Page Device Driver Installation and Configuration Configuring WindowsConfiguring Windows 95 OSR2 Configuring Windows Configuring Windows NT Page Found V.90 PCI Data/Fax Modem Port FC00 IRQ# Configuring DOS and WindowsWindows Apmdmcfg enter Configuring OS/2 WarpDEVICE=C\OS2\MDOS\VCOM.SYS Configuring UnixWareConfiguring the Modem For Linux Verified for Red Hat 5.2 # mknod /dev/ttyS4 c 4 # mknod /dev/cua4 c 5 Setting up and using PPP Setting Up and Using PPP Minimal Setup Configuring And Using kppp Using the Gnome Dialer AppletSetting Up and Using The linuxconf Dialer Some General Tips Configuring Your Modem’s Country Code S38 Default 56K Dial Line Rate AT Commands Affecting ITU-T V.90 OperationExamples S109 default K56flex and V.90 SelectionNo dial tone error Help and Service InformationNothing appears on the screen when I type In terminal mode Communications software does not workCan’t Connect at 56K Rates Open COM Port Error Message in W indows 95/98/NTReconfiguring a Windows Dial-Up Networking Connection Declaration of Conformity FCC Part 68 Requirements Telecommunications RegulationsIndustry Canada Class B Emission Compliance Statement

Related manuals

Manual 33 pages 1.47 Kb