Actiontec electronic 56K manual

Page 5

Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.

DANGER:

When using your telephone equipment basic safety precautions should always be fol- lowed to reduce the risk of fire, electrical shock, and injury to persons, including the following:

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightning.

Do not use the telephone to report a gas leak in the vicinity of the leak.

CAUTION:

Do not connect your modem to a digital PBX (switchboard) system, because you may damage the modem. Modems are designed to function with analog telephone lines, such as residential lines.

Do not connect your modem to an ISDN line. In some areas, ISDN (digital) lines are being provided for residences and businesses. These lines may damage the modem.

Please note that this modem is fully compatible with analog telephone lines that are connected to a Digital Exchange. A Digital Exchange is used in some areas to supply analog lines to homes and businesses.

5

Image 5
Contents Page Table Of Contents Contacting Actiontec Customer Support Product Registration Safety InformationPage Package Contents Product FeaturesHardware Installation Installing the ModemSystem Preparation For Windows 95/98/NTRemoving the Backplate Page Configuring Windows 95 OSR2 Device Driver Installation and ConfigurationConfiguring Windows Configuring Windows Configuring Windows NT Page Found V.90 PCI Data/Fax Modem Port FC00 IRQ# Configuring DOS and WindowsWindows Apmdmcfg enter Configuring OS/2 WarpDEVICE=C\OS2\MDOS\VCOM.SYS Configuring UnixWareConfiguring the Modem For Linux Verified for Red Hat 5.2 # mknod /dev/ttyS4 c 4 # mknod /dev/cua4 c 5 Setting up and using PPP Setting Up and Using PPP Minimal Setup Configuring And Using kppp Using the Gnome Dialer AppletSetting Up and Using The linuxconf Dialer Some General Tips Configuring Your Modem’s Country Code S38 Default 56K Dial Line Rate AT Commands Affecting ITU-T V.90 OperationExamples S109 default K56flex and V.90 SelectionNo dial tone error Help and Service InformationNothing appears on the screen when I type In terminal mode Communications software does not workCan’t Connect at 56K Rates Open COM Port Error Message in W indows 95/98/NTReconfiguring a Windows Dial-Up Networking Connection Declaration of Conformity FCC Part 68 Requirements Telecommunications RegulationsIndustry Canada Class B Emission Compliance Statement
Related manuals
Manual 33 pages 1.47 Kb