Vivitek DVR5612 manual Auto Config, Default, ADC Clock, ADC Phase, Position

Page 23

8 How to use OSD

♦ Stretch

12.AUTO CONFIG

An image fully fills the screen.

Press ok to auto get the input signal again.

♦ Dot by Dot

Detects the resolution of the signal and displays an image with the same number of pixels on the screen.

Notes:

*Wide Format is not available when using the POP, SPLIT functions.

*When you use 720p or 1080i signal input source. The screen will always keep STRETCH mode.

9. DEFAULT

Use ◄ ►to select ON or OFF.

ON

Mean call the factury default setting for Picture

 

Adjust.

OFF

Keep your picture adjust setting.

13.ADC CLOCK

Use◄ ►to change the clock value

Adjusting the image interference. When the screen shows interference caused by disturbing wave, please adjust the clock.

14.ADC PHASE

Adjusting Phase distortion of image in PC mode.When the screen shows flashing, ghost image or undulation, please adjust the phase.

10.H POSITION

Use ◄ ►to change image Horizontal position.

11.V POSITION

Use ◄ ►to change image Vertical position.

22

Image 23
Contents Page FCC Warning Accessories CheckClear methods MaintenanceMaintenance for filter Important StatementReplacement Procedure Replacement method of projection lampImportant Statement IndexDisplay Modes Correct viewing Remote ControlMoisture Condensation HandlingSafety Instructions Warning and Caution Do not touch the device and power cord while wet Keep this device from high temperature or direct sunshineKeep heavy objects off this device Install this device in a flat and solid placeKeep the ventilation grill free Do not stand or sit on this deviceBe sure to remove the plug by holding the power cord plug OUT Connecting and Checking the AntennaConnection with Antenna Cable System Connection Front ConnectorSpeaker System Rear ConnectorDVD, Satellite, Cable etc Stereo amplifierRear Connector Input Introduction the Control Panel and Remote ControlLamp / Power Status VOLVOL Button name FunctionOperation status Machine status Lamp LED Power onPower off Quick Input Source select way Example how to select correct input signal sourceBefore use OSD, You must know Recommended ways to learn about operationsTint OSD explanationBrightness ColorNoise Reduction Color TemperatureFor TV, AV, Comp input source mode For RGB, DVI input source modeADC Clock Auto ConfigDefault ADC PhaseSplit TransparencyPIP Close Caption Input SignalAnalog TV Setup Digital TV Setup Speaker BassTreble BalanceMpaa Rating Change Access CodeConfirm Access Code TV RatingOSD H Position OSD TimeoutReset ALL Setting Reset Lamp TimerCable set-top box codes Programming the universal remote controlDevice program codes Amplifier and tuner codesComputer and Home automation codes CD Player codesJBL DVD Player codesReceiver codes ADCManufacturer Satellite set-top box codesTV codes SSS JCBKEC KTVCCE VCR codesMGA MEI HI-QKLH To reassign device buttons Searching for device codesReassigning device buttons To search for a device codeTo access the OSD with the universal remote control Teaching the remote control new functionsUsing the universal remote control To teach the remote control a new functionTo set the sleep timer using the universal remote control Using picture-in-picture PIP modeSetting the sleep timer To control PIP mode using the universal remote controlRemote control will not accept the device program code TroubleshootingLED doesn’t blink when a button is pressed Miscellaneous Default PC Input ModeVideo Input Format SUB SpecificationsPlease check the following items If following situationsNormal Operation Error CodesStates Power LED Lamp LED Status Description LED StatusAnnouncement Service Information and AnnouncementService Information Page Vivitek Corp Fremont Blvd Fremont, CA Tel 510 Efax 510