Vivitek DVR5612 manual Troubleshooting, LED doesn’t blink when a button is pressed

Page 40

Programming the universal remote control

9

Troubleshooting

Use the following information to solve common problems.

The LED doesn’t blink when a button is pressed.

Replace the batteries.

Insert two AA batteries into the remote control. Make sure that you match the + and – on the batteries with the + and – symbols inside the battery compartment.

The LED blinks when a device mode is pressed, but the device does not respond.

Make sure that you are less that 15 feet (4.57 meters) from the infrared remote sensors on the device. Make sure that nothing is blocking the infrared remote sensors on the remote control or the device. Make sure that you have selected the correct device mode.

Make sure that the remote is programmed for that device. See “Programming the universal remote control” on page 29.

The remote control will not accept the device program code.

Make sure that you followed all the steps in the programming procedure. See “Programming the universal remote control” on page 29.

Make sure that you tried all the program codes listed for the device manufacturer. See “Device program codes ” on page 29.

Search for the device code. See “Searching for device codes” on page 36.

39

Image 40

Contents Page Accessories Check FCC WarningMaintenance Maintenance for filterImportant Statement Clear methodsReplacement method of projection lamp Replacement ProcedureIndex Important StatementDisplay Modes Remote Control Correct viewingHandling Moisture CondensationSafety Instructions Warning and Caution Keep this device from high temperature or direct sunshine Do not touch the device and power cord while wetInstall this device in a flat and solid place Keep the ventilation grill freeDo not stand or sit on this device Keep heavy objects off this deviceBe sure to remove the plug by holding the power cord plug Connection with Antenna Cable Connecting and Checking the AntennaOUT Front Connector System ConnectionRear Connector DVD, Satellite, Cable etcStereo amplifier Speaker SystemRear Connector Introduction the Control Panel and Remote Control Lamp / Power StatusVOL InputButton name Function VOLPower off Power onOperation status Machine status Lamp LED Example how to select correct input signal source Before use OSD, You must knowRecommended ways to learn about operations Quick Input Source select wayOSD explanation BrightnessColor TintColor Temperature For TV, AV, Comp input source modeFor RGB, DVI input source mode Noise ReductionAuto Config DefaultADC Phase ADC ClockPIP TransparencySplit Analog TV Setup Input SignalClose Caption Digital TV Setup Bass TrebleBalance SpeakerChange Access Code Confirm Access CodeTV Rating Mpaa RatingOSD Timeout Reset ALL SettingReset Lamp Timer OSD H PositionProgramming the universal remote control Device program codesAmplifier and tuner codes Cable set-top box codesCD Player codes Computer and Home automation codesDVD Player codes Receiver codesADC JBLTV codes Satellite set-top box codesManufacturer JCB KECKTV SSSMGA VCR codesCCE KLH HI-QMEI Searching for device codes Reassigning device buttonsTo search for a device code To reassign device buttonsTeaching the remote control new functions Using the universal remote controlTo teach the remote control a new function To access the OSD with the universal remote controlUsing picture-in-picture PIP mode Setting the sleep timerTo control PIP mode using the universal remote control To set the sleep timer using the universal remote controlLED doesn’t blink when a button is pressed TroubleshootingRemote control will not accept the device program code Video Input Format Default PC Input ModeMiscellaneous Specifications SUBIf following situations Please check the following itemsError Codes States Power LED Lamp LED Status DescriptionLED Status Normal OperationService Information Service Information and AnnouncementAnnouncement Page Vivitek Corp Fremont Blvd Fremont, CA Tel 510 Efax 510