Initial installation
Turning the set on/off
Switching the TV set to standby mode
Activate the mains switch on the bottom left of the set.
The display in the control panel on the front of the set will be illuminated red, the set is now in standby mode.
Switching the TV on/off on the control unit
First installation wizard
First installation after switching on for the first time
This wizard starts automatically after the set is switched on for the first time, however it can also be called later manually in the TV index, see Repeat initial installation on page 14.
First installation wizard
Which language do you want to use for operation?
Display
Press the on/off button in the middle for about 2 seconds to switch the TV set on/off.
Meaning of the display colour:
Red: Standby mode
Green: TV set is switched on
Orange: Radio mode, TV set receives EPG data or timer recording active
Initial installation
Language
| Sprache | D |
| Kieli | SF |
|
| Language | GB | OK | Jezik | SLO | |
| Langue | F |
| Jazyk | SK | |
| Lingua | I |
| Lisan | TR | |
| Idioma | E |
| Språk | S | |
| Taal | NL |
| Sprog | DK | |
| Jazyk | CZ |
| Idioma | P | |
| Γλώσσα | GR |
| Язык | RUS | |
| Język | PL |
| Språk | N | |
| Nyelv | H |
|
|
|
|
| OK Proceed |
|
|
|
|
|
|
|
|
|
|
|
|
Switching the set on with the remote control
Press the on/off button.
or:
numeric buttons
or:
TV button.
or:
OK button – station list is called.
Switching the set off with the remote control
Press the on/off button.
➠Before switching off the set with the mains switch, we recommend you to switch it to standby mode.
Switching on/switching to radio mode
Press R on the TV control unit.
or:
RADIO button on the remote control. (radio mode, see page 34).
The first step with the wizard starts when selecting the language for the user prompts. From this point on follow the instructions on your TV set.
Brief explanation of button functions:
Press the ring (up, down, left, right) to move the cursor and to select settings.
By pressing the OK button a setting is confirmed and you will go to the next step.
You can select or remove several items with the yellow button (see example below).
When an element is selected, it is marked by a checkmark .
Use this button to go back one step.
Exit the wizard with the END button (if available).
Initial installation
Connect antenna cable(s)
Antenna cable(s) for: | to antenna socket(s): | |
Antenna/cable (analogue) | ANT TV | |
ANT TV | | |
ANT TV |
| |
ANT SAT | | |
ANT SAT2 |
| |
| Connect/disconnect | |
OK Proceed | Back |
|
An example of multiple selection using the yellow button.
continued on the next page
11 - 