Loewe R 37 Full-HD+ 100, R 37 HD+ 100 operating instructions Conditional Access module CA module

Page 35

DVB

Conditional Access module (CA module)

In order to receive coded digital stations, a Conditional Access module (CA module) and a Smart Card must be inserted in the CI slot of your TV set (see page 5).

The CA module and the Smart Card are not part of the TV set's scope of delivery. They are usually available from your dealer. Loewe does not provide any guarantee for the functioning of the CA module.

Inserting the Smart Card into the CA module

Push the Smart Card into the CA module as far as it goes so that the side with the gold coloured contact chip is facing the side of the CA module marked with the provider's logo. Note the direction of the arrow printed on the Smart Card.

Inserting the CA module in the CI slot

➠Switch off the TV set's mains switch. Remove the cover from the rear of the set.

Ejector button

Cover

Carefully insert the CA module in CI slot 1 or CI slot 2 with the contact side forward.

If you are standing in front of the TV set (display) then the logo on the CA module must be pointing to the rear. Do not use force. Make sure the module is not twisted in the process. If the CA module is correctly installed, the ejector button protrudes a little further.

Replace the cover.

Searching for encrypted stations

➠The search wizard must only be started if the setting option no has been selected during first installation in the search for encrypted stations or no CA-module was inserted.

Call TV menu.

34Select Settings,

6 go to the menu line below.

34Select Stations,

6go to the menu line below.

34Select Search wizard,

6go to the menu line below.

34Select Change search settings,

OK wizard guides you through the search settings.

See page 24 for a description of the search settings.

Calling CA module information

➠This menu is only available for digital stations.

Call TV menu.

34Select Settings,

6 go to the menu line below.

34Select Miscellaneous,

6go to the menu line below.

34Select CA module: xxx

(xxx corresponds to the CA module provider), OK call information.

The content of this menu depends on the provider of the CA module.

Removing the CA module

➠Switch off the TV set's mains switch. Remove the cover from the rear of the set.

Press in the ejector button on the appropriate module drawer, the module is released.

Remove the module from the set. Replace the cover.

35 -

Image 35

Contents Operating instructions Contents Remote control TV functions Control unit front side of the device SD/HD-COMPONENT in Cb/Pb-Cr/Pr-Y component video inputs Factory settingsConnections rear side of the device Welcome Info display and TV index Operating convenience with wizardsWizards in overview Proper use and environmental conditions For your safetyPower supply Air circulation and high temperaturesSupervision Repairs and accessoriesVolume CleaningConnecting the TV set Initial installationInstalling the TV set Preparing the remote control unitTurning the set on/off First installation wizardDVB-S cable Explanations of the setting possibilitiesAntenna/cable analogue analogue stations via Call TV menu Explanation of the setting possibilitiesPositioning/aligning DVB-T antenna Explanations of the DVB-T antennaInfo display Operating convenienceGeneral information on menu operation Assist+ menu Index in the TV setDigital Link Plus Miscellaneous TV menu Overview diagramParental lock Timer functions Digital Noise Control DNC moreSwitch on TV when marked Settings Radio menu Overview diagramWake up signal volume Switch on TV when markedSelect station Daily operationExplanation of the icons following station names Select video sourceWith the favourites lists Explanation of the favourites listsAdjusting the sound Operation without remote control Adjusting the pictureButton functions Additional selection possibilities for DVB stations Explanations of the symbols for sound identificationOther setting options for DVB stations Status displayTV stations Search/update stations Search wizardExplanations of some search settings Managing stationsPAL, SECAM, NTSC-V, PAL60, Autom Search/update station manual search Call TV menuStation Input of the station colour standardDelete station Red button Starts Delete station Change, delete, move, rename, restore stationsRestore stations Green button Starts Restore stationsPut together / change favourites lists Picture in Picture PIP Picture in PictureConfigure Picture in Picture PIP mode Electronic Programme Guide EPG Electronic Programme GuideConfiguring EPG Teletext TeletextDigital teletext MHEG-5 Teletext menuRadio Radio modeConditional Access module CA module Software update Loading new software 34Select Start updateOK Start Software update TV base software or DVB softwareParental lock Other settingsTimer functions Call time and date On-screen displaysTime and date Call On-screen displaysConnection wizard Operating additional equipmentImmediate Signal typePlayback Digital Link PlusAV input can also be called manually, however Connecting a DVD player to the TV set56Select DVD, OK switch over Playback from AV deviceCamcorder Connecting a DVD recorder to the TV setConnecting Camcorder/camera Playback from AV device Call AV selectionDevices to the Hdmi DVI connections Devices to the PC in connection Devices to the Component in connection Integrated Dolby Digital decoder Sound components wizardConnecting SetupAdjusting the speaker system 34Select Configuration/modification Distance to left front speaker OK Continue to Adjust speaker levelOK Continue to Subwoofer phase OK continue to setMark the HiFi/AV amplifier Connecting audio amplifiersConnecting digital audio amplifiers Connecting analogue audio amplifiersRS-232C interface Assignment of the digital audio inputAudio connection in Hdmi DVI devices Direct way to record Timer recording with external devices PhotoViewer Calling the PhotoViewer menu Open folderMarking photos for slide show Starting a slide showSelect/play music MusicBoxConnection Starting the MusicBoxMusicBox Browse/sort Blue button Call Create play list MusicBox Play listsCall / play play list Create new play list / add titleMusicBox Menu Operating Loewe equipment Card Reader operation ViewVision DR+ „Home menu Functions for the Loewe DVD player Auro 2216 PS, 8116 DTUser interface of loaded DVD Menu original / playlist Rotating the TV set Troubleshooting Amplifier With Teletext various character sets areConnections max. equipment Technical dataGeneral data Electrical dataSetup possibilities AccessoriesAccessories Electronic Programme Guide See EPG Conditional Access module See CA moduleGlossary CI slot See Common InterfacePicture in Picture See PIP LCD Liquid Crystal DisplayHD digital TV analogueTV digital HD analogueIndex Service