Loewe R 37 Full-HD+ 100, R 37 HD+ 100 For your safety, Proper use and environmental conditions

Page 8

For your safety

For your own safety and to prevent unnecessary damage to your device, read and comply with the following safety instructions:

Proper use and environmental conditions

This TV set is designed exclusively for reception and reproduction of video and audio signals and is designed for living rooms or office facilities, and should not be operated in rooms with high humidity, such as a bathroom, or sauna, or where there is a high concentration of dust (e.g. workshops). The manufacturer‘s warranty is only valid for use in the specified permissible environment.

If the set is used outdoors ensure that it is protected against moisture (rain, splashing water, or dew). High humidity and dust concentrations cause leak currents in the device, which can cause a shock hazard if the device is touched, or a fire.

If you have brought the set into a

warm environment from the cold, then wait for about 1 hour before switching it on to avoid formation of condensation.

Do not place any objects filled with liquid or burning candles on the de- vice. Protect the set against dripping and splashing water.

Never place the TV set in a position where it is exposed to vibrations. This can lead to material overload.

Transporting

Only transport the device in vertical position. Grasp the device on the upper and lower edges of the housing. Never set the TV down on the protruding control unit on the bottom of the TV set. This could damage the control unit.

If the set has to be put down during packing/unpacking, place the TV set with the entire front surface lying flat on a soft underlay such as a blanket or the felt from the packing material.

The LCD screen is made of glass or plastic and can break if not handled properly.

If the LCD screen is damaged and liquid crystal escapes, wear rubber gloves when moving the device. In the case of skin contact immediately wash thoroughly with water.

Power supply

The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and frequency as that specified on the rating plate; use the mains cable provided. The mains plug of the TV set must be easily accessible so that the device can be disconnected from the mains at any time. When you unplug the mains plug, do not pull on the cable rather pull on the plug housing. The cable in the mains plug could be damaged and cause a short circuit the next time it is plugged in.

Lay out the mains cable in such a manner that it cannot be damaged. The mains cable must not be kinked or laid over sharp edges, stepped on or exposed to chemicals; The latter also applies for the entire equip- ment. A mains cable with damaged insulation can cause electrical shock and is a fire hazard.

Air circulation and high temperatures

The vent slots on the rear panel of the set must always be kept free. Please do not place newspapers or cloths on/over the TV.

Ensure that there is at least 10

 

 

cm free space on the sides and

 

10 cm

above the set for air circulation,

 

 

 

if the set is placed in a cabinet

 

 

or on a shelf.

10 cm

10 cm

 

Like any electronic device, your TV set requires air for cooling. Obstruction of the air circula-

tion can cause fires.

The set is suitable for different installation solutions. See the

instructions for assembly for the different installation solutions.

Stand the TV set with the table or floor stand only on a level, sturdy, horizontal base. Particularly ensure that the set does not protrude to the front when placed in or on pieces of furniture.

Set up the device where it is not exposed to direct sunlight and where it is not exposed to additional warming through heating elements.

Prevent metal items, needles, paper clips, liquids, wax, or similar items, from getting into the interior of the device through the vent slots in the rear panel. Such objects can cause short circuits in the set, which could possibly cause a fire.

If something should get into the interior of the set then immediately unplug the mains plug of the device and contact customer service for more information.

-

Image 8
Contents Operating instructions Contents Remote control TV functions Control unit front side of the device SD/HD-COMPONENT in Cb/Pb-Cr/Pr-Y component video inputs Factory settingsConnections rear side of the device Welcome Info display and TV index Operating convenience with wizardsWizards in overview For your safety Power supplyAir circulation and high temperatures Proper use and environmental conditionsRepairs and accessories VolumeCleaning SupervisionInitial installation Installing the TV setPreparing the remote control unit Connecting the TV setFirst installation wizard Turning the set on/offDVB-S cable Explanations of the setting possibilitiesAntenna/cable analogue analogue stations via Explanation of the setting possibilities Positioning/aligning DVB-T antennaExplanations of the DVB-T antenna Call TV menuInfo display Operating convenienceGeneral information on menu operation Index in the TV set Assist+ menuTV menu Overview diagram Parental lock Timer functionsDigital Noise Control DNC more Digital Link Plus MiscellaneousRadio menu Overview diagram Wake up signal volumeSwitch on TV when marked Switch on TV when marked SettingsDaily operation Select stationSelect video source With the favourites listsExplanation of the favourites lists Explanation of the icons following station namesAdjusting the sound Adjusting the picture Operation without remote controlButton functions Explanations of the symbols for sound identification Other setting options for DVB stationsStatus display Additional selection possibilities for DVB stationsSearch/update stations Search wizard Explanations of some search settingsManaging stations TV stationsSearch/update station manual search Call TV menu StationInput of the station colour standard PAL, SECAM, NTSC-V, PAL60, AutomChange, delete, move, rename, restore stations Restore stationsGreen button Starts Restore stations Delete station Red button Starts Delete stationPut together / change favourites lists Picture in Picture Picture in Picture PIPConfigure Picture in Picture PIP mode Electronic Programme Guide Electronic Programme Guide EPGConfiguring EPG Teletext TeletextTeletext menu Digital teletext MHEG-5Radio mode RadioConditional Access module CA module Software update 34Select Start update OK Start Software updateTV base software or DVB software Loading new softwareParental lock Other settingsTimer functions On-screen displays Time and dateCall On-screen displays Call time and dateOperating additional equipment Connection wizardSignal type PlaybackDigital Link Plus ImmediateConnecting a DVD player to the TV set 56Select DVD, OK switch overPlayback from AV device AV input can also be called manually, howeverConnecting a DVD recorder to the TV set Connecting Camcorder/cameraPlayback from AV device Call AV selection CamcorderDevices to the Hdmi DVI connections Devices to the PC in connection Devices to the Component in connection Sound components wizard Integrated Dolby Digital decoderSetup ConnectingAdjusting the speaker system 34Select Configuration/modification OK Continue to Adjust speaker level OK Continue to Subwoofer phaseOK continue to set Distance to left front speakerConnecting audio amplifiers Connecting digital audio amplifiersConnecting analogue audio amplifiers Mark the HiFi/AV amplifierRS-232C interface Assignment of the digital audio inputAudio connection in Hdmi DVI devices Direct way to record Timer recording with external devices PhotoViewer Open folder Marking photos for slide showStarting a slide show Calling the PhotoViewer menuMusicBox ConnectionStarting the MusicBox Select/play musicMusicBox Browse/sort MusicBox Play lists Call / play play listCreate new play list / add title Blue button Call Create play listMusicBox Menu Operating Loewe equipment Card Reader operation ViewVision DR+ „Home menu Functions for the Loewe DVD player Auro 2216 PS, 8116 DTUser interface of loaded DVD Menu original / playlist Rotating the TV set Troubleshooting With Teletext various character sets are AmplifierTechnical data General dataElectrical data Connections max. equipmentSetup possibilities AccessoriesAccessories Conditional Access module See CA module GlossaryCI slot See Common Interface Electronic Programme Guide See EPGLCD Liquid Crystal Display Picture in Picture See PIPTV analogue TV digitalHD analogue HD digitalIndex Service