Operating additional equipment
Connecting the audio signal from the PC or from the SetTopBox Analogue audio signal:
Connect the analogue audio signal from the PC or the SetTopBox via stereo cable to the AUDIO IN2 jack on the TV set.
The sound is played via the speakers connected to the TV set or a speaker system.
Digital audio signal:
➠An external digital audio signal can be reproduced via the integrated Dolby Digital Decoder or via an externally connected digital audio amplifier.
Connect the digital audio signal from the PC or the
The digital audio input can be assigned to the PC IN socket by the TV menu → Connections → Miscellaneous → Assign digital audio input, see page 47.
For an external digital audio amplifier:
➠External audio amplifier is already set in the sound components wizard (see page 46).
Feed the digital audio signal of the AUDIO DIGITAL OUT socket on the TV set to the external amplifier.
Connecting devices to the Component IN connection and playback
DVD players/recorders with component video connections can also be connected to the Cb/Pb Cr/Pr Y sockets (SD/HD- COMPONENT) of the TV set instead of to the EURO AV
sockets.
The connecting cable with three cinch plugs transmits the picture in- formation in better quality than is transmitted by a EURO AV cable. You need an additional cable for audio transmission.
Connecting the device
Connect the component video outputs of the external device via a triple cinch cable to the Cb/Pb Cr/Pr Y sockets on the TV set.
Connect the analogue audio outputs of the external device to the AUDIO IN1 L/R sockets on the TV set.
The sound is played over the speakers of the TV set or over a speaker system.
Alternatively, connect the digital audio output of the exter- nal device to the AUDIO DIGITAL IN socket of the TV set.
Call TV menu.
34Select Connections,
6 go to the menu line below.
34Select New devices/modifications.
OK calls the wizard.
OK Go to the AV equipment selection menu. Select device at COMP.IN.
Yellow button: Activate COMP. IN.
In an analogue audio connection, the sound is auto- matically played over the speakers of the TV set or over a speaker system.
A digital audio signal must be assigned via the TV menu
→Connections → Miscellaneous → Assign digital audio input to the COMP. IN socket, see page 47.
Playback from the device
Call AV selection.
| AV selection |
|
|
| DVD | AVS |
| HDMI1 |
MI2/DVI | COMP. IN | OK | VIDEO | VCR | PC IN |
34Select COMP. IN socket, OK to switch over.
Adapting the geometry (only possible with certain signals)
This is where the picture can be properly positioned and the position of the picture (horizontal and vertical) can be moved so that it fills the entire screen.
Call TV menu.
34Select and adapt the Geometry.
- 40