Operating additional equipment
OK continue to set the
Distance to left front speaker.
➠Measure the distances from your listening position to the front, surround, and centre speakers respectively. The Dolby Digital Decoder calculates the delay times for the speaker signals from these so that they reach the listener simultaneously.
| Sound components wizard |
|
|
|
|
| |||
| Please enter the distance of the left front |
|
|
|
|
| |||
| speaker from your listening position here. | 4,2m | 2,7m | 4,0m |
| ||||
|
|
|
|
|
| ||||
|
|
|
|
| 1,0m |
|
| 0,9m |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Sound components |
|
|
|
|
| |||
| Distance to left front speaker |
|
|
|
|
| END | ||
| 4,2 m |
|
|
|
|
|
|
|
|
| OK Proceed |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
34Set the distance between the left front speaker
and your listening position in 10 cm steps.
OK continue respectively to the other speakers and
34adjust the distance.
➠After setting the distance for the centre speaker ...
OK continue to Adjust speaker level.
Sound components wizard |
|
|
|
| |
You hear a sound from every speaker one after |
|
|
| ||
another. But you can also select the speakers | 0dB | 0dB |
| ||
manually with the menu control buttons up/down. |
|
|
| ||
Set the volume for the respectively active speaker |
|
|
| ||
shown in blue so that you get approximately the | 0dB | 0dB |
| ||
same volume impression from all the speakers. |
| ||||
|
|
| |||
|
|
|
|
|
|
| Sound components |
|
|
|
|
| Adjust speaker level |
|
| END | |
| 0 dB | Preceding/next loudspeaker |
|
| |
| OK Proceed |
|
| ||
|
|
|
|
|
|
34Adjust the volume for each speaker. Select speakers manually.
➠For balanced audio reproduction all speakers should be set at the same volume level. A noise signal will be reproduced automatically on each speaker in succession. reproduced automatically on each speaker in succession. Ajust every speaker to equal perceived volume from your listening position.
OK continue to Subwoofer phase.
Sound components wizard
Here you can reverse the phase of your subwoofer. Test both values in music reproduction and then select the one with which you get a better bass reproduction.
Sound components |
|
Subwoofer phase |
|
0° | 180° |
OK Proceed | END |
Switch to a station with music with P+/P– or start playback with music on a DVD player.
34Test both values (0º and 180º) and select the one with which you get a clearer bass reproduction from your listening position.
OK to confirm the setting and exit the wizard.
This ends the sound components wizard for connecting and setting up a speakers system.
45 - 