Loewe 32959022 manual Operating additional equipment, Device connection wizard, OK Proceed

Operating additional equipment

Device connection wizard

Connecting additional devices to the TV set

The device connection wizard serves to connect new devices to the TV set or make wiring changes.

➠New devices should not be connected until they have been registered in the connection wizard.

Call TV menu.

34Select Connections,

6 go to the menu line below.

AV equipment selection

Connection wizard

Specify all new AV devices to be connected and all connection changes to the existing devices here.

New devices/modifications

AV equipment selection

DVD	DVD player	
DVD •	DVD recorder	
VCR	Video recorder
	Satellite receiver
SAT
	SetTopBox/dBox
STB
	Decoder
Decoder
	Camcorder/camera
Camera
	Other device(s) to AV1/2/S
AV
	Device to COMP.IN
COMP.IN
	Device to HDMI1/DVI		END
HDMI/DVI
	Device to HDMI2/DVI
HDMI/DVI
OK Proceed		Connect/disconnect

34Select New devices/modifications. OK calls the wizard.

END: It is possible to run the wizard only partially at any time.

You have to confirm changes on a page with OK.

Connection wizard

Connect the satellite dishes or cable/terrestrial antennas of your AV equipment (recorder, decoder, ...) to the TV set according to the enclosed operating manual. The connection wizard assists you when you connect your equipment to the TV set via the AV sockets AV1, AV2 and AVS or via the SD/HD-COMPONENT IN or HDMI1/2(DVI)* socket.

Yellow button: Place a check mark after the devices to be connected.

OK Proceed.

The connection plan is displayed again. Connect the devices to the back of the TV set (in this example the DVD player (DVD) to AV1, the DVD recorder (DVD•) to AV2).

Signal type	New devices/modifications
	Signal type at socket AV1
	Automatic CVBS/YC	OK
	CVBS	END
	YC
	OK Proceed

Select the signal type of your set. Leave the setting on automatic if you are not sure.

OK Proceed

END

Connection example of a DVD recorder

TV set

Follow the instructions on the TV set.

The following illustrations provide an overview of the possible options.

Connection	Connection wizard
diagram	Now the TV set assumes that you have connected the following equipment:
		DVD	DVD
	AVS	AV1	AV2	COMP. IN HDMI1 HDMI2

ANT2

	AUDIO
AV2	digital
	In

DVD recorder

TV

OK Proceed

END

R

The connection diagram shows the devices that are cur- rently configured. DVD player on AV1 and DVD recorder on AV2 are factory pre-sets.

➠Use EURO-AV cable with angled plugs.

continued on the next page Ž

37 -