Metz 20 TK 51 operating instructions Before Switching on your TV, Switching the TV ON/OFF

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to op- erate on 12 V DC. For this, an adaptor is used which gives 12V DC voltage. Connect this adaptor to a system that supplies 230V AC, 50 Hz.

•After unpacking, allow the TV set to reach the ambient room temperature before you con- nect the set to the mains.

Connections to the RF input socket

VHF/UHF

•Connect the aerial or cable TV plug to the RF input socket located at the back of the TV and connect the cable plug coming out from the TV out socket located at the devices (VCR, DVB etc.) to this socket as well.

How to connect other devices

IMPORTANT: Switch off the TV before con- necting any external device.

Sockets for external connections are at the back of the TV. For connection of other de- vices via Euroconnector refer to the manuals of the related devices.

Inserting batteries in the remote control handset

•Remove the battery cover located on the back of the handset by gently pulling up- wards from the indicated part.

•Insert two AAA (R03) or equivalent type of batteries inside.

•Replace the battery cover.

NOTE: Remove battery from remote control handset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of battery.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:

1- Connect the power supply cord to the sys- tem. Then set the power switch to the "1" position . After this process, the TV switches itself to stand-by mode and the led becomes red located on the front of the TV.

2- To switch on the TV from stand-by mode either:

Press the “” button at the top of the TV, or,

Press a digit button on the remote control so that a programme number is selected,

or,

Press “P/Ch” button at the top of the TV or press “P-” or “P+” buttons on the remote control, so that last switched off programme is selected.

- 40 -