Panasonic NV-DV2000EC Edit Timing Adjustment, To select Timing Adjust, Adjust the timing for

Edit Timing Adjustment

When performing editing in conjunction with a unit which has a different mechanism, there may be a lag in the edit start point due to a deviation between the time a pause cancellation signal is received by the recording unit and the time recording actually begins.

Edit Timing Adjustment is used to compensate the edit start and end time in light of this start-up time deviation.

DIGITAL VCR

Programme Editing

After setting edit start/end points, the actual editing operation may start slightly before or slightly after the position that was set, depending on the equipment that is connected. The procedure described below can adjust the edit timing in order to correct for errors of up to ∫1 second in the edit start points and edit end points on the playback unit.

6Press OK.

7Adjust the timing for the edit end point in same way.

8Press OK.

9Press 34 (CURSOR) to select Start Insert (Assemble or Dubbing), and then press OK.

≥If the results of editing indicate that the adjustment is inadequate, repeat steps 4–8.

Notes:

≥The procedure described on these pages is to be performed after exiting the EDIT MENU screen. If this procedure is performed after having executed Start Editing or Review, start this procedure from step 4 on the Video Insert (Assemble, Audio Insert, AV Insert or Audio Dubbing) screen.

≥The adjusted frame unit is applied to all of the programmes that have been set at the moment when the adjustment is made.

Example: Video Insert

1Press EDIT MENU.

2Press 34 (CURSOR) to select Programme Editing, and then press OK.

On Screen Display

EDIT MENU

Copying

Video Insert

Audio Insert

AV Insert

Audio Dubbing

Programme Editing

3Press 34 (CURSOR) to select desired editing operation, and then press OK twice.

4 Press 34 (CURSOR)		Video Insert
to select Timing Adjust,		Confirm/Change
		Insert a programme
and then press OK.
		Erase a programme
		Preview
		Start Assemble
		Review
		Timing Adjust
5 Adjust the timing for the
		Timing Adjust
edit start point by setting			Mark In
the amount of the
	–			0f	r
discrepancy for the
start-up time.

≥The setting is displayed in frames (1/25 of a second) units.

Press 1 (CURSOR) if the start point is too early; Press 2 (CURSOR) if it is too late.

≥Each time the button is pressed, the tape moves by 1 frame.

≥Corrections can be made in the range of d30 frames.

54