Pelco C690M-E operation manual Rear Panel Connectors

REAR PANEL CONNECTORS

The components on the rear panel are shown in Figure 2. Making connections is explained in the installation procedures.

NOTE: SEE DIP SWITCHES THIS SECTION.

							EXTERNAL MODEM																				NTSC/PAL
										DX700EM																	MONITOR
28			1
																												1
	75										75
TERMINATION	1	2	3	4	5	6	7			8		9		10		11		12		13	14		15		16				D
SWITCH	HZ										HZ																		A
																										8		2	T
																													A
						N																					12
						T																							P
						N C																							O
LOOPING BNC						S C S															REL 1		REL 2					3
																									4	MON			R
																										OUT			T
					100-240~	N N P R	1	2	3	4	5 6	7	8	9	10	11	12	13 14	15	16	N	C N	N	C N					S
						S O A E															O	C	O	C				4
					50/60HZ	L S							ALARMS
				200 WATTS MAX
					5						3							COM 1
																					6
						10
																								7
																		COM 2				TCP/IP
						ON					DEFAULT IP			RESET
				11		OFF						9										10/100

N.O.

NOTE: SEE CONNECTING N.C. ALARMS SECTION.

SUPERVISED

NOTE: SEE
RESET	RESERVED
BUTTONS	FOR FUTURE	ETHERNET
IN THIS	USE
SECTION.

NOTE: SEE FIGURE 3 FOR DATA CONNECTIONS.

Figure 2. Rear Panel Connections, DX2016 Models

1Input and output BNC connectors (8 or 16 depending on model)

2Video termination switches

3Alarm inputs (8 or 16 depending on model)

4Two relay connectors

5Four DIP switches

6Two RS-232 communication ports

7One Ethernet port

8One BNC for connecting an analog monitor

9Two reset buttons

10Power switch

11Power cord receptacle

12Four data interface ports

12 Pelco Manual C690M-E (11/04)