9. Connect a PC.
•If a PC will be connected directly to the DVR, connect it at the Ethernet port on the rear of the DVR using a T568A/B
Refer to the charts below:
|
|
|
|
Wire 1 | White with an orange stripe |
|
|
Wire 2 | Orange |
|
|
Wire 3 | White with a green stripe |
|
|
Wire 4 | Blue |
|
|
Wire 5 | White with a blue stripe |
|
|
Wire 6 | Green |
|
|
Wire 7 | White with a brown stripe |
|
|
Wire 8 | Brown |
Straight-Through Cable
Wire | Becomes |
11
22
33
66
Crossed Cable
Wire | Becomes |
13
26
31
62
Figure 5. RJ-45 Color and Straight/Crossed Cable Pin-Outs Charts
•If the PC will be communicating with the DVR through an external modem rather than over a network, connect a Pelco DX7000EM External Modem to the DVR’s COM 1 port. Connect the modem to a phone jack. This will let you dial up the DVR to configure the unit or view live and recorded video. Response will be a little slower than over a network.
•If connecting to a network, go to step 11.
10.Configure the PC. Refer to the Configuring Your PC section.
16 | Pelco Manual |